Washing machine will not spin or drain

have Fisher and Paykel GWL11 it stops during the rinse

Please see the link there is manual

Fisher Paykel Ecosmart Use Care Manual

The pump has a thermal safety cut out on it.
If the pump gets too hot it cut out.
Just put a new pump in and your all going again.

Check the out of balance switch (under the larger Blue board)
for corrosion on the terminals and replace if faulty.

most likely you have a bad drain pump.or its possible you have foreign objects inside the drain pump preventing it from operating

lift the front of the machine and set on blocks about 3"

reach under to back to the blak flexable pipe and squeeze several times to loosen hair soap gunk eccetera.

start mahine on rinse cyle

it should start to drain on its own

I have a problem with my MW512AU. Sometimes it drains after wash cycle, but sometimes it sticks when it goes to spin, doesn't get up to speed, water comes on for about 10 seconds and shuts off, and it tries to spin again. If I hit the wash progress switch it goes directly to final spin and works ok. I then have to run a 2nd wash cycle to rinse the clothes. I also noticed a buzzing sound when I turn on the power point, which lasts about 3 seconds before stopping. It will come back on every 3-4 minutes for 30 seconds. This is with the machine power switch off. It powers on normally.

Check the drain pump, it may be overheating and cutting out.

the programer has given up the gost on you only thing you can do is try to replace it,,,

with no error code ... I would check you drain pump or drain hose... you first may want to try a shop vac connected to the end of a drain hose .. let me know if it helps