I get sound but no picture on my apex at2402.

Digital signals don't come from antenna. They come from the internet, or from a digital satellite receiver.
Then when you get the digital signals, you have to pay the provider for the channels you want to receive. As long as your provider does not know and did not sell you any channel you wont be seeing one.

I use an RCA box. Never had any problem.
How far away are the television broadcast antennas?
If they are farther than 40 miles, that may be the problem.
Hope this helps

Hi,

Please view this FixYa Tip which outlines the procedure for removing the parental lock when the screen is locked on the Apex TV.

Thanks for using FixYa.

your' TV is in VIDEO mode... connect your cable or sat. or DVD player or cable box etc. to TV using the VIDEO jacks>>>>red , white , and Yellow wires....picture should be on TV now.
other ways to get a picture also....changing TV from VIDEO mode TO TUNER mode...etc

Part # RRK12CC1, not original remote (no longer available) but is APEX made remote. At encompassparts.

You must have a monaural (mono) TV even though it looks like you have speakers on each side. The VCR has stereo audio output red=right white=left yellow=video. Ideally you would buy a mixing tee to add the left and right signal. Or if your VCR supports it you can set it to mono output. Otherwise, just use the white (left) cable to feed the mono input (white) and of course the yellow to yellow for video. Just ignore the red wire or lightly tape over it to avoid any short. Best,
-Ken

Try changing your screen size,you may have it zoomed in but its something to check.

ok, you need a step down transformer :)

I had a paper for a remote... think it is the phillips universal remote.
it said apex tv codes were as follows: 023 and 741
apex audio is: 068
apex dvd is as follows: 044 146 347 545 547 640 644 740 741 840

best of luck

worked just fine for me! thanks!!! 'function' key is in the top left hand corner