Jen Air jjw9530bab F4 code

Question edited for clarity.
Question moved from Misc category.

GE Wall Oven F4 Error Code Explained

https://appliancerepairguides.com > ge-wall-oven-f4-err...
Dec 23, 2021 - The Ge Wall Oven F4 Error Code is an oven temperature sensor fault. It means the temperature sensor is shorted (under 950 ohms). The temperature ...

Hello there:
whenever you get this error code F4 or even the f3 error code this is telling you that the ovens temperature sensor/probe is faulty and is unable to sense the temperature of the oven correctly.
So the fix for this is to get a new sensor OK SO IF YOU WILL GIVE ME THE MAKE AND MODEL # OF YOUR OVEN I CAN SEND YOU SOME PART INFORMATION ON THIS OK?
best regards mike

Hi, the F4 error code means Open or shorted oven temperature sensor (RTD)..
Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok.

Hello,

F4 is a fault with the temperature sensor for the oven which normally will need replacing.Hope this helps.

F4 means there is an open circuit in the Oven Temperature Sensor. Could be a bad sensor that needs replacing, cound be an issue with the wiring harness.

A test would be to short the sensor wire together at the sensor. the error code should change to F3. then you would know it is the sensor and not the harness.

HI. This is a failed oven temperature sensor error code. Simply replace the temp sensor, asap. This will clear the code. The temp sensors are generally located inside the oven, mounted on the back wall, in the top left or right corner.

It will look like a 4 inch slim probe.

F4 failed temp sensor.

how do I solve a F4 problem in the Decor electric stove?

f4 is the code for a shorted oven probe try first replacing it

Slone, F4 is the code for a shorted temperature sensor. This is the temp probe in the oven. There are 2-quarter inch screws holding it on. It should pull out through the insulation until the quick connect comes through. If you want to make sure, the sensor should ohm out at 1143 ohms at 100 degrees. I think you can be pretty sure that this is the problem. The part number I have is 704657. Catriver.

f4 means it has a shorted oven temp. sensor and will need to be replaced.