No power to Hoover Wind Tunnel Vacuum

Question edited for clarity.
Question moved from Cars and Trucks.

Described as a 'fixable design flaw'.

https://www.google.com/search?q=Hoover+Wind+Tunnel+2+brush+roll+on%2Foff+pedal+not+working

..

Your motor may have siezed. You may have a cut in the cord somewhere too. Need more specifics to pinpoint problem. Did it stop working suddenly? Did it smoke of smell funny the last time it worked?

First of all you have checked to make sure you are plugging into a outlet that has power correct ? If you have power at the outlet then when you activate the switch does it make any noise at all ? If not you may have a defective switch. If it's making a noise you may have a broken belt or something jammed in the brush.

There is a thermal sensor in the motor which shuts power off if it gets too hot but usually it won't turn back on until it cools down. It seems you might have a defective switch

there are two belts on the wind tunnel this video will show you how to repair

there could be a short in the cord or the switch is bad

If you turn the vacuum over there will be (4) screws that hold on the base cover for the roller brush. Remove the screws and the cover and you can get to the belt(s). You can get replacement belts here:

Hoover Windtunnel Belts

Hello my good friend, this cleaner doesn't have a reset button or anything, it resets by itself after cooling down, it takes about 30 minutes to cools down.

that is a pretty good lifespan for a hoover, but its probably the power switch that's bad. Hoover uses a very poor quality switch. It shouldn't cost to much to have it replaced

Need a manual for Hoover Vacuum Cleaner, Wind Tunnel Model:u6630900