Couple of things to check: there's a float that needs to more freely, make sure it does. There's dishwasher cleaning instructions in the operation manual. You may need to take the lower rack out, take off the spray arm to get at a filter, which you should clean and replace. Then you can try to run some white vinegar through a wash cycle. Jean Air has these instruction at their web site.
SOURCE: whirlpool dishwasher # quiet partner II
THIS WORKED FOR ME!
push" heated dry",then "normal" then" heated dry" then "normal"--it worked like a charm..did the happy dance,washed dishes and saved $130.00!!
SOURCE: Maytag Quiet Series 300 dishwasher, dishes come out dirty
A water softner will not make the dishes any cleaner, it just makes it so they don't have water spots on them.
If the dishes are dirty, it is most likely that the nozzles (holes) in arms may be plugged.
Also check to make sure you are getting plenty of water to dishwasher. Make sure all water valves are full turned open.
If the control panel does not work all the time, it is very likely you have either a shorted wire, or a fualty main board which is very common in newer machines.
SOURCE: Clean light is blinking. Services manual says:
Hi
Thanks for using FixYa. That means the control sensed that the heater in
the D/W did not operate 3 times in a row. So the unit locks out. First remove
the kick plate and you may have to pull the unit out from under the cab, but
check your heater. Use a meter to see if it reads open; if so orders a heater
assay it will come with a new control replace it too. If heater checks good
then press in sequence normal wash, heat dry, normal wash, heat dry, normal
wash, heat dry three times within 6 sec and all the lights will come on then
hit cancel. What that did is reset the control and clear that fault. Keep in
mind that D/W does not heat its own water and incoming water temp should be
120. The D/W will maintain that temp. When starting your D/W first turn on your
hot water till it gets hot then start your D/W this ensures your unit fills
with hot water and not cold
Please do rate the solution and revert for further
assistance.
Thanks
Rylee
SOURCE: 1.5 year old Maytag Legacy Series Quiet Series 300 Lock Light on
Hold down the heated-dry button for 3 seconds and the light will clear.
SOURCE: My Jenn Air Quiet Series
Here is a link that will help narrow it down http://appliancehelponline.com/dishnopowervideo.html
614 views
Usually answered in minutes!
×