Replacing fuser pc1610

perform the following steps to remove the paper jam.

1. Lift the platen unit lever and slide the platen unit.
2. Open the cartridge cover.
3. Remove the cartridge from the machine.
4. Flip the transfer guide.
5. Gently remove any jammed paper from inside the main unit.

More items...
•
May 22, 2018

PC1060 paper jam - Canon Community

community.usa.canon.com > PC1060-paper-jam > td-p


VIDEOS as well

https://www.google.com/search?q=clear+paper+jam+in+a+Canon+PC1080F%2FPC1060

..

i need to find a replacement LCD TFT Screen for Canon IXUS i SD10 digital camera Model number PC 1060

need to replace the drum unit.

First replace drum cartridge

Power supply problem

you sould not have to remove the scanner unit to clear a jam in the fuser

open all doors and remove anything marked green

remove the the cartridge assembly if it will come out

open the fuser section (usually a release that takes pressure off of the fuser rollers

remove the paper feed cartridge

you now should be able to follow the paper feed path from the time paper goes i until it comes out

if you are not sure of path take a piece of card stock and simulate it goig through feed ara

there are small microswitches/ poto eyes that sense paper lok for an small pieces also clean thes poto eyes with q tip and rubbign alcohol


reassemble

unlug from the wall then plug back in and turn on p roblem sould be solved

make sure that the exit sensor is realese down.generaly u ca check the sensors not to have pull out 

The fuser comes out the left side, not from the top of the copier.

Here's the definitive reset. It will work on the following models: ImageRunner 1200/1300, PC1060/1061/1080F, ImageClass D620/D660/D661/D680/D681
Press Additional Functions key
Press #
Press > to #7 Printer Function
Press Set
Press > to #4 Printer Reset
Press Set
Press <
Unplug printer and repower it.

hi i am a certified Canon tech on this copier. the problem you have is due to the scanner cable that runs from the top of the scanner to the main board in the back of the machine. what happens is when you take the scanner unit off to get to the fuser screw holes the cable should be removed from the main board under the rear panel with alot of screws. some people when they put the scanner unit back on they dont watch the position of the cable and when the unit slides back to open the cartridge door the cable is pulled part way out of the board connecter. the first thing i would do is to remove the back cover and chech the connector for the scanner cable to see if the cable is in all the way. also sometimes i have found that some one has pinched the ribbon cable damaging it underneath the scanner and replacing it with a new cable took care of the problem. the cable cost around $20. hope this helps.