I have 2 phone lines into my home and I'm trying to use my Meridian M8314 phone; when I plug in both lines and try to make an outbound call, it puts the call out on both lines.
How can I program the phone to give me "Line 1" and "Line 2" buttons?
SOURCE: Programing outside (CO) line button
press program button then press the flexible where you want program the CO line then press 0, here u can select which CO line need to be program.
Ali
Testimonial: "Brother Ali I appreciate your help"
SOURCE: Hi there ... We have 4 lines in the office but on
Programming is done on M7310, M7324 and T7316 sets.
To set up line appearence you need to enter programming by pressing the feature key followed by **266344.When prompted to enter the password enter 266344.
The screen should say TERMINALS&SETS. The 4 top line/feature keys are now used for programming.
At the terminals&sets prompt,
press the show key (top right arrow).
The display should now ask for an extension number. Enter extension number you wish to program the new lines on.
Press the show key (top right arrow)
The display should sat LINE ACCESS
Press the show key (top right arrow) .
The display should say LINE ASSIGNMENT.
Press the show key (top right arrow) .
The display ask for a line number. press list
The display should say line 001: appear & ring
press the next key (bottom right arrow) till it says 003:unaaign.
press the chng key till the screen says appear&ring
Press the next key(bottom right arrow)
The display should say line 004: unassign
press the chng key til the screen says appear&ring
press the Rls key when finished
SOURCE: By mistake I have pressed the program buttom, then
Press PROGRAM line 1 and dial 0 1 STORE
That brings back line 1 to the button.
Carl
Testimonial: "FANTASTIC"
SOURCE: We have an old Meridian
A couple of thoughts. What happens when you ask about line 2 (as in Feature *0 and press line 1 then line 2 etc to see what it says). If line 2 is really there, and you can PICK UP but not see it ring, it could be programmed as Appear Only in system programming. If L2 doesn't appear at all, although it's highly unlikely, it could be that your phone is only told to have ONE line. Again that's a system program.
The admin instructions should have all of the access codes and it's just a stepping process to program terminals and sets.
Carl
81 views
Usually answered in minutes!
×