Kenmore Top...Brand new, loud icemaker & door vibrating

suggestion, i suspect you have got something in the wash pump or the pump impeller is breaking up this can cause a vibrating noise or it could be the rince pump.

1) What brand and type water heater? Gas or electric? Tank or tankless? Or boiler? Solar assisted? Indirect? Wood-burning? Oil-fired? etc?

2) How old is heater? Is this a new installation? Or installation that worked before and vibration is something new.

3) Or are you talking about a washing machine instead of water heater? Or hair dryer? Or GMC truck?

4) Add a comment and give more exact information from label located on side of unit, for possible assistance.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

When the factory packs the machines for shipping they install 4 bolts that lock the drum in place. Were these removed when the Washer was installed at your house? They need to be removed completely otherwise the machine will make a lot more noise and vibrate loudly.

People, the first words the poster said were that the dryer was "brand new". All of your suggestions assume the dryer had extensive use. This sounds like a factory defect issue!!!! My brand new Maytag Cabrio gas dryer is also making an obnoxious buzzing sound that seems to cycle on and off as the gas ignites. The buzzing sounds electronic not mechanical. What would buzz when the burner is active?

The icemaker is pretty simple, there is a motor, a solenoid, and a couple of switches.

It sounds like the whole icemaker mechanism is jammed or has a broken gear, and the motor is trying it's darndest to turn the stuck mechanism (grinding it's gears in the process), or the gear has already gone, and what's left of the gear is dancing around in there.

http://www.repairclinic.com/Appliance-Parts?s=t-frs26r4a-%3d%3dc248

My guess is either the $7 icemaker drive gear or the $94 icemaker assembly.

It sounds like the Freezer Fan and Icemaker Fan are going bad. They are located behind the back wall of the bottom freezer chest. These are very labor intensive to replace.

Sounds like the compressor is going out on thermal overload. Call a service technician to look at it.

icemaker

After reading these posts, I fixed my refrigerator door in less than 5 minutes. The little black plastic cam on the bottom hinge was loose. To fix it, take the hinge cover off of the top with an 8mm socket, and remove the three 8mm screws holding the top hinge on. Remove the door by lifting up off of the bottom hinge and set it aside. On the bottom hinge is a black plastic cam held on by an 8mm screw. The screw on mine was really loose. Tightening it and putting the door back on made it work like new. You probably don't have a bad cam, just a loose one.

For Tegres
If the noise is only when there is water flowing, check tighten the screws that mount the water fill solenoid valves to the case. The solenoids operate on line current so they vibrate at 60/50Hz (local suppply frequency) if they are loose at all, the noise is loud the body acts as resonators

For SRONEAL, that symptom describes coupling failure exactly, have you removed the coupling to check, often times the motor side hub is stripped, but there is no visible external damage