Have a kenmore washer and I have to run everything thru 2 spins cycle

Washer Repair - Not Advancing -Repair & Diagnostic ...

? 8:30
https://www.youtube.com/watch?v=IEr9A7uhdN8
Sep 6, 2013 - Uploaded by ApplianceVideo.com
Repair your Kenmore Top Load Washer suffering from these following issues: Will Not Advance Past Rinse ...

Kenmore washer doesn't complete final spin cycle - ApplianceBlog

www.applianceblog.com/.../31894-Kenmore-washer-doesn-t-complete-fi...
May 16, 2012 - 9 posts - ‎2 authors hello, my kenmore washer doesn't complete the final spin cycle. i ... Does it stop in the middle of the final spin cycle or does it not go into the ... FIXED Kenmore Washer - Not finishing the spin cycle
9 posts
Dec 20, 2014
FIXED Washing Machine Does Not Complete Cycle ...
10 posts
Mar 14, 2013
FIXED Kenmore washer won't spin out all water from ...
10 posts
Jun 27, 2009
FIXED GE front load washer WCVH6260F0WW stops ...
10 posts
Jul 2, 2007
More results from www.applianceblog.com

the door on top the switch on it has failed
so the machine wont start a cycle

Duet washer service manual

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

1) 1st check the filter under the machine (it unscrews behind the access panel 2) open front door and pull back the rubber membrane to see metal and clean out the debris blocking drain holes 3) remove the drain hose from the machine (spring clip) and try and run water thru it and keep blowing out the junk and re-attach 4) run the machine thru 2 cleaning cycles w/bleach and without bleach 5) start using less detergent

The pump either got some old sock in it, or the pump cold be clogging up with left over sop,

replaice door swith

I believe this is the direct drive model. Your clutch is slipping. There is a quick easy fix available that I have used in the past. Remove cabinet from washer. Make sure you know the easy way to do this... 2 screws on top back of washer and 2 holding control panel. cabinet tips toward from of unit and off. Real easy... Remove wire harness from motor under basket. Remove 3 screws holding motor to basket. Remove agitator inside basket. 1 screw holds it in place. Remove entire motor and shaft from unit. Clutch is attached to shaft on top of motor. Pinch spring to remove clean everything with alcohol. Insert #10 washer between cup and spring to give a little more tension. Replace and viola.... all should work well.

The pressure switch is mis-reporting the water level to the ECU.

Test/replace the pressure switch.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

you have blockage in you drain plug. to solve this problem you'll have to remove the lower front panel of your machine by removing the 3 (1/4") screws on the vary bottom of the machine. once the panel is removed you'll see a 1 1/2" white PVC drainage plug. turn the inner plug to the left in till open. (WARNING ALL THE WATER IN THE DRUM WILL DRAIN THOUGH THIS PLUG) remove debris likes socks or everything that's there replace the panel and your all set.

your pump is partially clogged or your drain hose is kinked