VS-50603 Mitsubishi tv is locked. Requesting 4 digit password

When the cable company offers you digital cable, you typically need a cable box to unscramble the digital channels. Therefore you need to connect either a coaxial cable from the cable box's RF output, if it has one, or connect 3 RCA cables from the yellow, white and red jacks on the rear panel of the cable box to the TV. Analog channels only (if available) will go straight thru over the coaxial RF hookup. They are not scrambled. Select the proper input source on the TV for the cable box.

Hi Friend,
Please folliow the below steps one by one

Step 1: Turn on the TV

Step 2: Hold the ON/OFF Button for 10 to 20 Secs

Step 3:Without taking the hand from the ON/OFF button unplug the power cable connected to the wall outlet from the TV

Step 4:Without taking the hand from the ON/OFF button put the power cable back to the outlet

Step 5:Now take the hand from the ON/OFF Button and try to turn it ON again and check

If still you are having the same problem then please check the resolution configured in the Screen,try to reduce the Colour and the brightness of the TV

Even after that you are facing the same issue please check with the Display Card in the TV,

If you have any Clarification please feel free to contact us

Regards,
Ayyasam

The power supply will need to be changed. The capacitors inside the power supply are not sending the correct amount of power to tv and will need to be changed.

Indoor antennas have very limited capabilities especially in areas with elevation changes and heavy tree cover. Ideally, you should put an outdoor antenna on your roof or the highest elevation you can find with a relatively short distance to the TV. Make sure it has a good UHF section as this is where all digital broadcasts will be sent by the broadcasters as the digital transition occurs. You might try an amplified indoor antenna for better results than what you have now, but its no substitute for an outdoor antenna.

michtech

connect headphone-. did you hear sound?

Good Day, ariley1604;
Please contact comcast, and look into U- VERSE.
Good Luck, big IRISH.

I can help you unlock your Mitsubishi HDTV V-Chip.

Please follow these steps to bypass the vchip or reset the V Chip password.

I hope that helps.
_______________________________________________
Reset Mitsubishi HDTV VChip Password
Bypass Mitsubishi HDTV Front Panel Lock

happened to me also. Go to the menu, select setting, thrn av (home theater) and see if "locked to input 1" is "on". Mine was. then I set it to "off" and everyting works great

I have a VS 50607. My manual gives instructions that may work for your set. See the attached pic.

If you are not a tech the tv needs to go to a tech to be fixed.the probleis in the power supply or related circuit good luck.