RCA F32650 32" White lines with hazy white flickering

Hello
Along with the flyback transofrmer, its horizontal output transistor also must be replaced. I don't know whether you have replaced it or not. If not, replace it too. It can be located very near to the flyback transformer, a three terminal component, black in colour, usually screwed to a metal heatsink. Then switch on the TV and measure the video output voltage at the video output card pluged directly to the picture tube neck. The collector of the video aoutput transistors must come around 145VDC. If it also is there, advance the screen control on the flyback transformer to get a raster. If that voltage is not there, it means that the flyback transformer is not working, and horizontal oscillator stage should be checked for oscillation, check the lined drive transformer for its primary winding open, Check the entire horizontal oscillator section. The collector point of the line drive transistor, the transistor that drives the line drive transformer, a small transformer soldered diretly to the printed circuit board; should be checked with frequency meter. The frequency at that point should come around 15525HZ approx: OK.

your flyback transformer is dying real fast considering there price and there availability i would be looking at buying a new tv


sorry

merry christmas

could be the flyback starting to breakdown

Cold solder joints on the flyback transformer circuit board - probably because RCA used feed-thru steel rivets on their boards. Re-solder the connections using a good solder flux for clean solder joints and this will fix prob. The joints with the dull, pitted finish are the problem joints.
S. Hampton

My color wheel went out on mine and it looks to be the same on yours'. RCA cannot find a replacement for my model and there are none available on an on-line search. RCA may end up replacing my set.

Go back to FBT check and make sure your high voltage wirer is in good.

Your tv has a video problem, leak capacitor in video section, near in flyback need to replace it.

mine did the same thing on a cable line and then i put rca cable on it and it never did it again

Single white line across screen mean a vertical colapse. So you will need the vertical output and maybe a cap around 100uf@50v.

When you have the back off, look for the flyback (high voltage) transformer. This is the part that has the thick red wire protruding from its top which attaches to the top of the picture tube with a suction cup. On the flyback there are 2 controls, the bottom one is screen and the top one is focus. Turn the bottom control (screen) down (counterclockwise) until the white lines go away and the brightness looks normal. Then turn the top control (focus) until the picture is nice and sharp. If the F connector has been pulled out and the TV has RCA (red, white, yellow) jacks, use those jacks and set the TV to INPUT.