I need speakers for my Westinghouse LCD tv, Model # SK-19H2105

No, unfortunately not. There is no internet connectivity to it. It was released in August 2010.

http://www.hdtvsolutions.com/westinghouse-sk-32h540s.htm

and the manual is here

Westinghouse SK-32H540S LCD TV User Manual - HDTV ...

http://www.hdtvsolutions.com > 206_User_Man
PDF
E If the interference persists even after performing the above measures, consult the Westinghouse Service. Center or an experienced radio/TV technician for ...


..

Press the “Menu” button on your remote or the side panel to access the On Screen Display

(OSD)

—Use the right/left arrow buttons to scroll across to the “Setup” menu

—Use the up/down arrow keys to select “TV” and “Quick Setup”

• Use the arrow keys to select your “Time Zone”, which allows you to receive

proper HDTV programming information

• Continue with arrow keys to select your signal source “Air/Cable/IRC/HRC”

—If you use a rooftop or indoor antenna, select “Air”

—If you use a cable service, select “Cable,” “IRC” or “HRC” (depending on the frequency

used by your cable service)

—Press the left arrow key to start scanning for channel

Try this link

http://www.manualowl.com/m/Westinghouse/SK-26H730S/Manual/241441

Len

if older tv check caps in power supply.

Westinghouse TV SK-32H240S http://legacywd.com/pdf/111_User_Manual.pdf

Hello

WHITE WESTINGHOUSE Codes: 097/ 100

Four digit codes for white westinghouse are : 0100 0130 0138 0136 0227 0279 0080

four digit codes for wetinghouse are: 0143 0114

OK

Look for bad caps as shown here: http://s807.photobucket.com/albums/yy352/budm/Westinghouse%20SK-19H210S/

If you are going to DIY and have proper tools and know safety precaution then please read on:
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply (they should be replaced in a set), blown fuses; poor solder joints, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.

http://en.wikipedia.org/wiki/Capacitor_plague
Capacitors kit: http://lcdalternatives.auctivacommerce.com/ he can make you a set of caps for you

Try unplugging it . Wait a few seconds and plug it in again.

caps in power supply

turn the timer off.