Large right/front burner is out of control. Regardless of the setting, the burner heats very high. In fact, recently, oliver oil in a skillet ignited. Even though the control was set to less than medium, the ignition occurred within one minute. HELP!

The switch controlling the burner is just a voltage controlling unit (rheostat). It needs to be replaced

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

Faulty switch if you are changing it yourself remember turn off power and take your time, take a photo to compare so you get it right.
Good luck. Ray

Hi, Sorry I missed this as it got buried in my emails. The part number for the switch you need is WB23M0009 costing about $70.00

the stove you have takes someone with an electrical knowledge to test and you don't want to break the to!!!.that said test burner for continuity if there control board bad

You need the switch for that burner. The contacts inside are stuck together. You will need to pull the unit and separate the glass from the lower body to access it. To get the right switch you need full model and serial number located on a plate at the bottom of the unit.

Your ability to perform this is dependent on how mechanical you are. The Whole unit must be removed from the counter opening and the base unscrewed from the glass, remove knobs before disassembling. For someone mechanical this is not difficult. De-energize whole unit first.

Once the two pieces are separated the remainder is mechanically easier. Disassemble the box on right containing the switches and replace the correct one. Reverse the process for reassembly. Good Luck

not related any further then sounds as if you have 2 burner switches gone bad,and actually the front right burner is controlled by a electronic control circuit board part retails for about $160-$200 part number 12002723, and left rear switch about $30 part number 74007841 . uint needs to be uninstalled from counter and parts changed by removing the bottom panel

Sounds like the Switch or the element are bad, try trouble shooting them. It's a stove top??
Eddie Rentas
Tupper LAke NY

Sounds to me like the RF switch is bad.
Eddie Rentas
Tupper Lake NY

Switch that controls that burner is bad and needs replacing

I have had this same problem on the JP350.

I have replaced the switch several times, and am now tempted to replace the heating element and the switch the next time it becomes constant (currently, it is intermittent... which has led to some burnt food).