The screen on my braun shaver has holes and needs replacement can i get new ones for it? its the one that says caution for use only with braun series 549 class 2 power unit www.braun.com it has a trimmer for side burnes etc..

Braun Select Models Electric Shaver Disassembly Tutorial
1. Remove two screws on the bottom, where the power plugs in. Need to remove two ribber plugs first.
2. Pull from shaver head and remove shaver "guts" from case. (It will be hard to remove as it is encased in rubber to make it waterproof, but keep wiggling and tugging)
3. Remove old batteries and replace with new ones.
4. Re-assembly is reverse

You will find a replacement foil for Braun shaver type 5 235 at shaveroutlet.com. See link below

http://shaveroutlet.com/shaver-replacement-parts/braun-1000-series-linear-synchron-foil-p-135.html

Braun 7526 replacement foil and cutter blades is Braun series 3 combi 30B foil and cutter replacement pack.

You will find the replacement at shaveroutlet.com. See link below.

http://shaveroutlet.com/braun-7000-series-syncro-motor-drive-unit-p-110.html

To open the shaver body, you will first need to gently pry off the 'cap' on the bottom that surrounds the hole where the cord plugs in. Once removed the side grips will pull off revealing 4 screws. Remove screws to take off back cover and access insides. Inner parts simply lift out.

For Braun 7000 series shavers, you will find replacements at shaveroutlet.com. See link below.

http://shaveroutlet.com/braun-7000-series-syncro-foil-and-cutter-p-141.html

Hello Brian, You can give the folks at www.electricshaver.com a try. They typically stock all the replacement and repair parts for most brands of electric shavers.

Here's a link to their site where you'll find part #5646768 for about $38 for a new set of the cutter head and foil (screen). It's always best to replace BOTH the foil and cutter block (head) at the same time, as any mircro burrs or nicks in the cutter blades will quickly ruin any new foil screen.

http://www.electricshaverstore.com/get_item_5646768_braun-foil-cutter-kit-360-complete-8000-series.htm

As you know, this is the simplest and easiest way to get an electric shaver back to a "like-new" shaving experience.

I hope you find this Very Helpful and best regards!

Hello Robert, It sounds like the foil screen might have been damaged and is causing poor shaving performance. Typically, a screen will get small holes or tears in it after providing good service for some years, however, these very thin screen foils, can get damaged other ways too.

The best way to restore the best shaving performance is to replace both the foil screen AND the cutter head block (cutter head) as it could be possible that the cutter blades have become damaged or nicked and have caused the foil screen to become damaged, as a result.

I would contact www.electricshaver.com and see if you can purchase a new set of the cutter block head and the screen foil for your particular Braun shaver model. As the Braun 360 is a tradename used on a couple of different model numbers, you really need the four (4) digit model number in order to locate the correct replacement parts.

Here's a link to their page with the various Braun replacement cutter blocks and foil screens. You might find your model number amoung them, otherwise, you can also give them a call at 1-888-476-1785 and ask them to assist you with selecting the proper replacement parts.

http://www.electricshaverstore.com/get_list_125.htm

As you are no doubt aware, replacing the cutter head and foil screen is the best and simplest way to restore an electric shaver to a like new shaving condition and much less expensive than replacing the entire shaver.

I hope you find this Very Helpful and best regards!

YES! it is the razor you need to replace it after that no more pain

Hello MrandMrsInger! You can purchase a new replacement foil for your Braun 370 at the link I've provided below. Basically, you'll be getting a new cutter block and foil for it, as the foils are no longer provided separately.

Braun, now owned by Gillette, discovered that many folks would buy just the new screen (foil) and it would get torn/damaged by a nick in the cutter block blades, so they packaged these wear items as a set to eliminate those very common problems. I had it happen to mine several years ago, so I know why they made the change.

Anyway, here's the website with your replacement parts:

http://www.electricshaverstore.com/get_list_125.htm

Just scroll down to the 2nd item shown, I believe, and you'll see your replacement set.

You can also use the part numbers to try to locate another supplier, if you wish, as these are the actual Braun part numbers provided.

Hope you find this Very Helpful and best regards!

This particular Braun shaver was made in both a US and European version. They are similar, but take slightly different cutter blocks and foil screens, sooooooo

If you bought your shaver in the US, then you can get a replacement foil here for around $8.00 or you can find another supplier of your choosing.

http://www.ecrater.com/product.php?pid=4997848

If you bought your shaver in the UK, then a replacement is available on Amazon.com (UK site) for quite a bit more in British pounds.

http://www.amazon.co.uk/Braun-Replacement-Foil-Cutter-System1-2-3/dp/B0000X5HPK

Hope you find this Very Helpful and best regards!