Code A08 is flashin how do i solve this - Indesit 24 in. DE73 Evolution Free-standing Dishwasher

A08 - Open/Short circuit auxiliary wash motor triac -

This is the power transistor that carries motor current. It is signaling that it is blown, but this usually happens when the circulation motor is faulty. Both need checking, and likely replacing.
You may be stuck with a bill for a new motor AND a new control board.

hello

The "oe" error code is an indication of a water temperature sensor error. There is a chance that there is a loose wire connection on the water temperature

mean while "oe" error code indicates that the water temperature sensor reading is out of range (below 23 degrees F or above 217 degrees F).

however,what you need to do tp fix up the problem is to unscrew the washer then clean up all forms of dry and water you can seen in it with this the problem of the "oe" error code is solve .

please make sure that all form of power supply is put OFF before you can do this

thank you and thanks for using fixya.

download this file from intel ,it will solve your problem.the url is given below
http://downloadmirror.intel.com/18052/a08/infinst911_autol.exe

does it affect the vehicles funtionality? if not i'd say a loose light socket or a shorted wire is likley the cause

A08 - Open/Short circuit auxiliary wash motor triac -
Hope this helps

See this diagram.
http://fileshare.eshop.bg/index.php?what=search2

(search for CDC A08 if link doesn't work)

Basically, 12v to pin '3' (with notch at top, it's the top row, third pin from the RIGHT) and ground to outter jacket of the connector. Push eject button, works a charm.

Cheers.

I am waiting for a reply from the Authorised Blaupunkt Service Agent for a solution to this problem &
shall let you know when it is solved. As per my telcon with him it is an alignment problem of the
Cartridge carrier, but he will have to look at the Unit later, when he is free.

A08 is a problem of the mother board , i changed this and i paid 130.000 for a **** ten minutes of work but i didn't resolve the problem. i waiting for another mother board.

Sounds like it has overflowed at some stage. Ensure the filter is cleared and then rock the dishwasher backwards. Any trapped water will drain out and the safety valve will reset. i had similar and this was what the indesit technician did.