Closed door, pushed clean button, but door lock button keeps flashing and door won't lock.

Hello Steven Krenz - Was the unit in self-clean mode? Try pressing and holding the "Clear/Off" button to stop any operation of the EOC. Do this at the same time while pushing and hold the light switch to the left of the door lock. Usually this will trick the oven into unlocking the door. If it is ineffective, try resetting the unit by unplugging it or flipping the household circuit breaker off. Wait approximately ten minutes and redo the steps. If door continues to maintain locked while open, the unit may possibly have a faulty door latch or a communication problem with the EOC. Contact a professional to move forward accurately.

Hello - Does any part of the range work? I would recommend verifying that a fuse is not blown or a circuit breaker tripped. Test the power outlet with a lamp, hair dryer, etc. Another questions, does "Loc" appear in the display if any button is pushed? The Oven Lockout feature automatically locks the oven door, prevents the warmer drawer and most oven controls from being turned ON. If so, press and hold CLEAR/OFF for 3 seconds. A beep will sound. LOC will clear. The "DOOR LOCKED" will continue to flash until the oven door has completely unlocked. Does the clock display "Sd" or "dddd"? If so, the clock is in sales demo mode. Press and hold the "BAKE TIME" button for 6 seconds to exit sales demo mode. If this does not prove to be successful, contact a professional to have EOC diagnosed and/or to confirm that there isn't a wiring failur

Unplug it. Plug it back in, then press n hold start. Make sure lock handle is all the way locked. You may have to push on the door at same time while locking n unlocking. If that doesn't work, shoot it. Ha

Hi

F9 is a door lock error and to solve this issue you can hold the light switch for 15 seconds, this will reset the control. If it won't work then hold the light switch in and set the unit to clean and after a minute press cancel to cancel the clean cycle. If still it won't work then the door lock assembly should be replaced. Hope this helps...please post back for further assistance.

Daniel

Check out these steps at the following link... http://www.geappliances.com/search/fast/infobase/10004586.htm

Range - "LOC DOOR" flashes in the display

If "LOC DOOR" is flashing in the display of your range or oven, and the self-clean cycle has not been selected, follow the steps below to reset your control:

Motorized Switch

1. With the door open, locate the door jamb switch on the face of the oven. It will look like a small black post or dowel.
2. Push it in until the oven cavity light goes off, indicating that the oven believes the door is closed.
3. While you hold the door jamb switch in this position, complete the following steps.
4. Press the Clean pad, wait 10 seconds.
5. When the cycle initiates, press the clear/off or cancel pad immediately to cancel it.
6. Wait 10 seconds for the display to clear.
7. The door should unlock and there should not be a need for service.

Manual Switch

1. Press the Clean pad.
2. Close the door.
3. Slide the latch to lock the door.
4. Hit the cancel button immediately.
5. Unlock the door.

Range - "LOC DOOR" flashes in the display

If "LOC DOOR" is flashing in the display of your range or oven, and the self-clean cycle has not been selected, follow the steps below to reset your control:

Motorized Switch

1. With the door open, locate the door jamb switch on the face of the oven. It will look like a small black post or dowel.
2. Push it in until the oven cavity light goes off, indicating that the oven believes the door is closed.
3. While you hold the door jamb switch in this position, complete the following steps.
4. Press the Clean pad, wait 10 seconds.
5. When the cycle initiates, press the clear/off or cancel pad immediately to cancel it.
6. Wait 10 seconds for the display to clear.
7. The door should unlock and there should not be a need for service.

Manual Switch

1. Press the Clean pad.
2. Close the door.
3. Slide the latch to lock the door.
4. Hit the cancel button immediately.
5. Unlock the door.

http://www.retrevo.com/samples/Frigidaire-Oven-manuals.html
Your user manual above.

check the interlock switch, can be some object has stuck to it...

push in on the oven light switch and hit clean then cancel you have to hold the oven light switch thats what tells the eoc the door is closed if this dont work reply to me

most of the time a simple fix.... http://www.geappliances.com/search/fast/infobase/10004586.htm
you have to trick the door lock mech into cycling through the cleaning process (takes about 20 seconds)
Print Range - “LOCKED DOOR” flashes in the display

If “LOCKED DOOR” is flashing in the display of your range or oven, and the self-clean cycle has not been selected, follow the steps below to reset your control:

Motorized Switch

1. With the door open, locate the door jamb switch on the face of the oven. It will look like a small black post or dowel.
2. Push it in until the oven cavity light goes off, indicating that the oven believes the door is closed.
3. While you hold the door jamb switch in this position, complete the following steps.
4. Press the Clean pad, wait 10 seconds.
5. When the cycle initiates, press the clear/off or cancel pad immediately to cancel it.
6. Wait 10 seconds for the display to clear.
7. The door should unlock and there should not be a need for service.

Manual Switch

1. Press the Clean pad.
2. Close the door.
3. Slide the latch to lock the door.
4. Hit the cancel button immediately.
5. Unlock the door.

If the above does not correct the situation, a service technician will need to check your cooking product. To obtain in or out of warranty repair on Major Appliances, you may call 1-800-GE-CARES (800-432-2737) or schedule service online.