I have bought jbl on time 200P dock station for ipod with radio but all the freq in radio is odd numbers and i need to change it to even numbers

Is this a new problem? Did it work before? Have you tried to check out your manual to see if there is a reset for this device? Here is a link to your manual if you do not have it: http://www.manualslib.com/manual/618267/Jbl-On-Time-200p.html?term=troubleshooting&page=14#manual

It seems an issue of the dock connector of your Iphone, please check if there's no contact blocked or bended, if there's one or more contacts with these conditions, you may need to replace the dock connector of Iphone.

You can pick up an ipod docking station adapter here.

i need to connect my ipod docking device to my laptop in order listed my music from the laptop louder throygh the device. i bought a usb cable in order to connect the lap top to the jbl device ?

Get one of these to sole your problem. ipod change their charging circuit I found one at Walmart in the ipod accessories section. Its called the Passport home dock adapter.
http://www.scosche.com/products/productID/1695

- this accessory supports charging for the iPhone 3G, iPod touch (Gen 2) and iPod nano (Gen4) with most iPod docking stations
- Snaps into any iPod universal dock and accepts universal dock adapters

You need to change the radio type to Europe, by default it is US. Check the manual on how to do this.

AM is just another name for MW. The Radio should tune to a strong signal regardless of the frequency the radio is set to. It should also sweep the entire frequency looking for stations. I'm assuming it has a channel scan setting, plus options to set a number for the station. AM/MW are very much dependent on the position of the either internal or external Ariel. If you have the radio in the wrong position or you have some electrical equipment nearby it could block the signal for the station you want, but not affect the others. Which might explain why it can't find the station you want.

Yes it can

Fullers Electronics on 01728 746400
The board part number is: ZDTIMEWT0100G

I have had exactly the same problem having bought a JBL Radial Micro for my partner for Xmas for use with the Ipod Nano, i contacted JBL via their website and was advised to contact Harmen on 01707278100. I was advised that the new ipod nano (chromatic) would not charge on the JBL radial micro. They stated that this was due to Apple changing the charging pin in the new nano. I have since bought a JBL Stage III. I contacted Harmen before buying this and was advised that the Stage II would not work. Hope that this is of use.

No luck finding repair, so have accepted that mini jack into ipod and aux-in socket in on-time will have to do. My daughter is satisfied!!