I have got 2 or3 1inch thick black lines running top to bottom of screen since the screen got slightly knocked
Had the same problem. Was quoted $800 to fix. Searched the internet for 6 months and found this thread on avforums.com http://www.avforums.com/forums/showthread.php?t=462873&highlight=black+line+on+plasma&page=4 Read through all the posts. Very simple fix, but you have to have some mechanical inclinations or you can cause more problems than you started with. I was up to 5 of the black lines, but decided to attempt the soldering these guys did and fixed it all for the cost of a soldering iron! Even if you decide not to attempt it, it gives you somewhere to start to tell a technician.
If these are thick black lines, this is most likely line frequency noise entering the set. you may have a leakage from the DC ground on the secondary side of the powersupply to the AC side, or a bad filter capacitor(s). Most of the time it is the filter caps that give these types of problems. If you are connected to cable TV service, or an outside antenna you can also have this problem from an AC ground loop return. Also if there is a device such as a VCR connected to the TV and it has problems, it can cause this as well...
Hi all .ive had the same problem,a thick black line down screen.sometimes it flickers from top to bottom and other permantly in view.but i have solved it.forget your ic boards and taking apart tv.have you got either a ps3 or wii connected to tv.if so unplug power lead from socket and relocate in seperate socket.make sure the lead is completely free of any other leads and you might just find this works.i think the power lead creates some sort of frequency that the tv picks up .good luck hope it works
Did anyone find a solution for this problem? I have the same TV and it has a single black line down the middle of the screen.
Hi
Have a look here. I have found the problem with mine and it took all of an hour to fix at no cost.
Suggest you dont throw these away but throw them in my dircetion :)
http://www.fixya.com/support/t129859-30m...
×
My too, did you figure out the problem? I just have one 1" thick fuzzy black stripe from top to bottom that is not pefectly straight.
Brian
If this set has impact damage, chances are the panel is damaged. The FPC cables connecting the panel may have connection issues as well, this would be repairable, replacing the panel itself is not economical. Joe Weibel
SOURCE: 30mm. vertical black line on screen.
Hi I have just fixed this problem on my screen. The fault was a dry solder joint on the driver circuit of the screen. Have a look at my thread here. I have tried to explain it as well as possible. Hope it helps.
SOURCE: plasma
Hi , This is a common fault and easily fixed ,Ive posted some stuff under the hyundai 4240 section, 3 inch black lines , Please go through all the posts as there are links to photos to help you along , Tip , Use a digital camera for log you process so you know where all the screws and cables go , also , lift the brown strip upwards and slide the ribbon cable out ,and do the repair to them all..you understand once you read all the links
SOURCE: hyundai plasma
go here and watch part one and two
http://www.youtube.com/watch?v=9NPobj0_GSo
4,571 views
Usually answered in minutes!
when i turn my tv on plasma there are lines going up and down the screen like 8 or 9 and the pic shows blurry , wobble type.
have the exact same plasma with the same problem. have black line about 2 inches wide running from top to bottom of screen.always in exact same position. this line was coming and going but seems to be coming more frequent. can anyone tell me whether this is fixable and what sort of cost i might be looking at.
i got the same problem
I have a black rectangle, 3 inches wide, half screen height, on the top half of the screen. Looks bad, will not go away, no matter what. Ideas?
×