Blade for Patton Stand Fan Model 1010-MP1

I'm not all up on Patton Model#s, but this is an older unit, correct? You may try contacting Patton (Owned by Holmes now so you may have to go through them)

If they cannot help you, try www.dtvintagefans.org There's collectors there that may have parts fans that they may be willing to sell a blade.

Alternatively, you may try Grainger, as they sell an assortment of blades. You will need to match a blade to your motor though, which should be fairly easy as the Patton fans use a common McMillan motor which most attic fans also use.

it would be far cheaper and more easy to replace the entire unit

There is usually a pin in the shaft of the motor, that corrosponds with a slot in the fan blades, it sounds to me like either (a) the pin somehow came out, or (b) the slot in the blades is rounded. Hope this helps

i have a good blade for model #u2-1887.

put motor oil to the midst of your fan blade may there are lots of rust inside then wait 5 hours then try to pull again patiently...

go to ur nearest electrical shop and tell them the model and the brand name buy that and fix it but you wont be getting a sigle blade you ll get the blades in a set not as single you need to remove all other blades and fix the new blades

Any Blade will be ok if it will fit shaft and they all should be cosistant and of course the higher the amp the better quality.I like the Pro 3 model at Home depot but I believe the Pro 1 gable is the 12 inch blade,pro 3 is 17 inch houseing and maybe 12 inch also.

Please rate jj505 Guru

I have a metal blade for the Patton U2-20 fan listed on ebay. The item number is 160273949463 and the listing ends on Wednesday August 27 at 10.00 p.m. I had this fan for 8 years and the motor has failed. Patton could not replace the motor since this is a discontinued item, and I figured that someone could use another blade for their fan. I hope this helps you!

I have one of these pieces of junk. The motor swarmed, so the rest of the fan is perfect. I'll sell it for $10.00 plus shipping.
Skip [email protected]

Hello

This would seem to be the motor heating up and cutting out on a thermal overload. Check to see if the motor area is clean and that the fan blades are clean. To clean the motor you can blow compressed air through it. To clean the blades disassemble the cover remove the blade and clean with a mild soapy solution.