I just finished replacing 6 CAPs on my power board after having the flashing green power led symptom.
After putting the set back together I get the steady red status led and the error code indicates 41 (short detected).
Any suggestions.
PS. I replaced two caps on the power board 6 months ago and the TV worked fine after words.
Mitsubishi V26 error code 41 with solid red status indicator is caused by leakage from capacitors C9A37 and C9A38 (3300mf/16v). The result is a bad fuse F9A02 (15amp pico) which reports error code 41 indicating short protect. The Mits part number is 283P144040 but any PICO 15a fuse will work.
Bill W.
Integrityhomeworx.com
A steady red light: there is a short on the DVI cable from FMT to DMD disconnected
SOURCE: Mitsubishi WD-62525 Red Status Light After Cap Replacement
which caps did you replace? As the normal repair for the first generation dlp is to replace the (4) 1000 uf caps. the (2) 2200 uf caps and the (2) 3300uf caps on the power pwb when you get the 34 error code.
1,080 views
Usually answered in minutes!
I have Mitsubishi 62525 and blinking green light on front panel. I read a lot of 4 capacitors to be replaced. Are there any instructions available how to get to the board. I opened TV's the back panel but have no idea how to get to capacitors.
I have a WD62525. I was watching it one day and it just shut off and the status light went red. I spoke to a tech who said it was likely a set of caps on the power board. He came to my house and got code 41 out of it and found a 15A fuse blown on the power board but not the cause of a short.
×