Flashing CH 24 i just picked it up from home depo bran new today what could it be ?

Hello everyone, can someone please tell me what is error code CH10 on lg dehumidifier please?
Thank you

Thanks for the post by Posted by Bill L on Jul 14, 2012.
I decided to take a chance and order the new Sensor assembly $20.50 and install it in my LG LD651EBL Dehumidifier which was giving me ch 67 errors. Wala, it worked, the error code is gone and the dehumidifier is now working perfectly! Thanks

There may be some packing material left in the bucket or tape that is holding the float valve in place. In which case, the float valve may be in the UP position, which tells the unit, that the bucket is full.
Check the top of the bucket for the float valve and make sure it's in the DOWN position. Reinstall the bucket 'squarely" in the bucket holder and making contact with the bucket safety removal switch on the rear wall of the bucket holder.

If this continues to happen, consult the Troubleshooting Guide in the Owner's Manual.

Hope this helps and thanks for choosing FixYa.

Hi,

Here is a tip that explains what can be happening to make the dehumidifier showthat the bucket is full when it is not.

Dehumidifier Problem It shows Bucket Full

heatman101

';
';
';
;'
;'

If the bucket is in place correctly, turn the unit OFF & unplug it for 10 minutes. This should allow the electronics to rest and revert back to the original factory setting after you plug it back in and turn it ON. From there you should be able reset the controls to your liking.

Hope this helped. Thanks for choosing FixYa.

Leo, have you removed and emptied the buck and reinstalled it? If not, that's the first thing you need to do. If you have already done that, remove the bucket and if it's equipped with a float valve in the top of the bucket, make sure the float is not stuck in the UP position. If it is, jiggle the arm of the float, so that it will return to the DOWN position.

If not equipped with a float valve, when you reinstall the bucket, be sure that it fits "squarely" from top to button into the holder.

NOTE: Before attempting any of the above, turn the unit OFF and unplug it it.

Hope this helps you troubleshoot and solve the problem.

In the trouble shooting section of the manual they do list err 24 and tell you to call the service center. They will arrange a service tech to come and deal with it. Or tell you to take it back to the store.

Just so I have the data point. Do you have it hooked up to a hose or are you using the built in bucket?

No it is not the cord.

Try it with the bucket instead of the hose.

Let us know what happens.

Had same erroe code in 2008. CH 01. Bucket Full light was flashing, but it was empty. Would not start. Called customer service and was advised it was most likely a compresser problem. In that compressoe was still in warranty took it to a lacal service center. Compressor was Ok, but had to replace Evap Thermister Board and Sensor. $120.00 in parts and $50.00 labor.
I am not an expert.
Good luck.

I had the same problem, and I wound up calling LG's customer support line. The rep I spoke with says that the "CH" code means that the internal thermostat is not able to accurately read the air temperature, and the unit will require servicing.

She gave me a couple of numbers for local folks, and I'll call them in the next day or so, but I'm thinking that this may not be worth the repair, unless it's pretty cheap: I bought the unit for under $100 less than 9 months ago, and I'm not eager to shell out a bunch of money to get it repaired.