Where can I buy two capacitors for my Mitsubishi WD-52525 52 in?

Good day!!!!


That problem is usually cause of faulty capacitors on the power supply board..

Just follow this instruction to fix your TV..

1. Open the back cover of your TV.
2. Look at the power supply board..Its normally connected to the power cord..
3. After that,,try to look at the actual image of capacitors if it is bulged on the top so that you can easily determine the bad capacitors..
4. After that,,try to replaced the bad capacitors using soldering iron and soldering lead..replaced the capacitors only with the same type ratings and value..
5. Some of the capacitors not bulged so its better if have a capacitance meter

Good day!!!!


That problem is usually cause of faulty capacitors on the power supply board..

Just follow this instruction to fix your TV..

1. Open the back cover of your TV.
2. Look at the power supply board..Its normally connected to the power cord..
3. After that,,try to look at the actual image of capacitors if it is bulged on the top so that you can easily determine the bad capacitors..
4. After that,,try to replaced the bad capacitors using soldering iron and soldering lead..replaced the capacitors only with the same type ratings and value..
5. Some of the capacitors not bulged so its better if have a capacitance meter

Good day!!!!


That problem is usually cause of faulty capacitors on the power supply board..

Just follow this instruction to fix your TV..

1. Open the back cover of your TV.
2. Look at the power supply board..Its normally connected to the power cord..
3. After that,,try to look at the actual image of capacitors if it is bulged on the top so that you can easily determine the bad capacitors..
4. After that,,try to replaced the bad capacitors using soldering iron and soldering lead..replaced the capacitors only with the same type ratings and value..
5. Some of the capacitors not bulged so its better if have a capacitance meter

That model will usually have 8 caps that require replacement on the Power board and also 4 capacitors on the DM board which will usually cause the Non stop blinking light symptom.

If you have a green blinking light,
Most likely issue is with bad capacitors on the DM an FMT boards.

1) Look for bad 1000uf 16v caps on the dm board and the fmt board.

2) checked surface mount fuses (small white boxes) on DM and FMT board

Look carefully for other bad capacitors in the general area.

Start here and let me know the results.

Note, there is a lot of disassembly to get to these boards. Not a fun project.

Don't think dm board will solve your issue, might want to check power board for buldging caps.

disconnect the connector for the front switch control board. Try turning it on with the remote. If it works replace that board, also look for bad caps on the small signal board. they're 1000Mf 16v

ok.
#1. replaced capacitors on power board. DM board FMT board .
# 2 on power board you need to chek caps. 3300mf x 35 v.QTY 2.
# 3 12 capacitor 1000mf x 16 v.
If caps 1000mf x 16 v . looked good. replaced anyway......

?? give description of problem?? plug it in and hookup some cable!

I get the same red lamp led indicator, bought the lamp and I am unable to locate the lamp inside the tv, took the lower back panel out and don't see anything that i can make out the lamp housing. is hard to replace the capacitor and where is the power board located. thanks a mill.