PIXMA MX330 Error message "Document in

Hello,
The sensor may be dirty even if it looks like there is no paper jam. Take a bottle of compressed air and give it a once over. Make sure you don't shake or tip the compressed air as you don't want to fast freeze anything.
If this does nothing, you probably have a failed sensor which will need replacing.
Chris

PIXMA MX330 Error message

Hi,
Welcome to Fixya. If you have an error Document in ADF please follow the steps below.
Remove the document following the procedure below.

(1) If printing is in progress, press the Stop button.
(2) Turn off the machine.
(3) If a multi-page document is loaded, remove any pages other than the jammed page from the ADF, then open the Document Feeder Cover.



(4) Pull out the jammed document from the ADF.




(5) Close the Document Feeder Cover, then turn on the machine.
When rescanning the document after clearing the error, rescan it from the first page.
If you cannot remove the document or the document tears inside the machine, or if the document jam error continues after removing the document, contact the service center.
Note: The document may not feed properly depending on the media type, or your environment, such as when the temperature and humidity are either too high or too low.
In this case, reduce the number of document pages to approximately half of the loading capacity.
If the document still jams, usPIXMA MX330 Error message "Document in - ezrahite_9.giflass instead.


When rescanning the document after clearing the error, rescan it from the first page.
If you cannot remove the document or the document tears inside the machine, or if the document jam error continues after removing the document, contact the service center.
Thanks for using Fixya.