Is it possible to control DiMAGE A200 from PC? (when DiMAGE A200 is connected to PC.)

It's always possible that someone has one on Ebay that you can use for parts.

I can be fixed, but will be expensive. Get a local quote.

Format the cards in the camera. Make sure you download any pictures that might be on the cards first. Use a card reader if necessary.

I have the same camera. It will use up to a 4GB card as standard and up to 8GB with the correct firmware.

Check the following web address for further information: -

http://ca.konicaminolta.com/support/americas/digital_cameras/dimage-a/dimage-a200/software_drivers/firmware/installation_guide.html

I hope you find that my answer has helped, if so please return the favour by rating my answer.

Sorry, the lens is fixed onto this camera. It's not possible to change it.

BUT there is a solution; you can but a small lens to screw into the front of the existing lens like a filter.

There is one to get better close ups (super macro I s'pose) and another to get better telephoto.

There's a page about them in the hand book somewhere near the back. Gives the Konika part numbres and so on.

The firmware for telephoto converter/ wide-angle converter is included in the attached CD-ROM. Please update it if you have DiMAGE series 7i to A1. Please confirm the firmware version and update it if you have DiMAGE A2 and its version is 1.10. DiMAGE A200 users do not need the firmware updating.

The DiMAGE A200 sensitivity can be set to Auto, ISO 50, 100, 200, 400, and 800. When Auto is selected, the camera automatically controls the sensitivity within the range of ISO 50-200.

No, it is not. But the camera can automatically balance the CCD sensitivity to enable autofocus even in low-light condition.

Yes, it is possible to control the camera from PC with "DiMAGE Capture DCA200". (sold separately) It is necessary to update the camera's firmware to use with the DiMAGE Capture. (the firmware is included in the CD-ROM attached with the product.) * DiMAGE Capture DCA-200 will be available at the end of March, 2004.

Yes, it is possible to control the camera from PC with "DiMAGE Capture".(sold separately)