Tromm washing machine, front load from LG

OE means uneven load.
If you can open door, put a dry towel in with the washing and try spinning again ...

OE means Water may not drain properly
This causes:
Your pump is clogged.
Your pump is not connected.
Make sure your pump is repaired, and try again.

Follow the link for help diagnosing this error code http://www.lg.com/us/support/product-help/CT10000010-1337714738535-oe

An OE error presents if the washing machine has not successfully drained the water in ten minutes. Follow this link for step by step instructions for correcting the OE error code.

The FixYa Team

The LG error code OE simply means "the pump is blocked". Presumably the water isn't being emptied properly. As with all error codes it is possible that there is a cause other than the exact description in the error code explanation but basically this error means as far as the washing machine is concerned it thinks the water isn't pumping out. A pump, or filter blockage is the most common cause but it could be caused by other faults such as a faulty pump, or even a blockage in the drain hose or somewhere else in the system etc.


LG themselves have some information on this error code..

http://lgknowledgebase.com/kb/index.php?View=entry&EntryID=6273

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.!!!!!

check your drain lines and see if they are cloged because that is what it sounds like if not then try the pump

Not sure what the OE is, but I;ve been having the same letters flashing on my washer this week. I checked the filter at the bottom and it was totally plugged up ! I would check your filter.

the OE message means that the machine has not fully drained out all the water. you can try to re set on drain or you may need a service call. hope this helps.

unit not drainning..in the but front left hand corner ,,there a panel,,open panel and clean your filter...onthejob...

oe is an error code for pump problem disconnect power cord open small door on lower front of cabinet pull little tube out and plug from tube and drain water in to bucket after water is drained unscrew cap of pump to clear out any obstructions reinstall the cap and plug and give a test run