Top 20 AT&T 650530003417 Cordless Phone Questions & Answers

0helpful
1answer

I am having AT&T E5913B, it was working fine few

check battery weak or not.
10/30/2013 6:38:29 AM • AT&T... • 42 views • 0 helpful votes
1helpful
1answer

My att cordless phone mics

It's not that the handsets have bad mics, the problem is in the base unit. That's what's sending audio into the phone line, and something has gone wrong there. Try unplugging the power from the base and give it a minute, then reconnect the power. This will allow the computer inside to reset and may straighten out the trouble. If it doesn't, you're probably best off replacing the system.

AT&T doesn't say anything on their site about service, just to call their Customer Support and Service Center at 1-800-222-3111 for more information. If your phone is out of warranty, it's probably easier and maybe less expensive to buy new.
7/28/2011 10:44:31 PM • AT&T... • 571 views • 1 helpful votes
0helpful
1answer

AT&T cordless phone #cl81219 message

Hi,

Try reset that particular cordless phone, Turn off the phone, remove the AC adapter, press and hold the page/call button that is on the phone and plug back your Ac adapter, that s
hould fix the problem.
8/13/2011 7:35:50 PM • AT&T... • 313 views • 0 helpful votes
0helpful
1answer

Had a bad electrical storm.

The damage is not to the phone line it is to the phones. Unfortunately this is very common with powered phones as they are almost never kept on surge protectors and are very fragile. You will need to purchase a new base station to use with existing phones.
4/29/2011 3:10:07 PM • AT&T... • 430 views • 0 helpful votes
2helpful
1answer

I have a AT&T model

Hi,

You can try reset your phone, Turn off the phone, remove the AC adapter, press and hold the page/call button that is on the phone and plug back your Ac adapter, see if this fix the problem.
3/14/2011 4:45:13 AM • AT&T... • 683 views • 2 helpful votes
0helpful
1answer

Im from japan country how can i call my friends in

you may visit some mobile sites.......
6/1/2011 9:57:07 AM • AT&T... • 74 views • 0 helpful votes
0helpful
1answer

No dial tone. Incoming calls get busy signal.

all u need to do is to flash your phone
3/11/2011 10:47:54 PM • AT&T... • 236 views • 0 helpful votes
0helpful
1answer

Phone is not working

Unplug your Phone and plug in a regular un-powered phone. If it rings your cordless base station is bad and you will need a new one if it does not ring then there is a problem on your phone line and you need to contact your phone company. Note, the phone company will charge you for repairs inside your house.
3/2/2011 7:18:17 PM • AT&T... • 90 views • 0 helpful votes
0helpful
1answer

I have a cordless AT & T Phone will stop

The battery in the handset needs to be replaced, your battery is at the near end of it's useful life.
1/4/2011 1:59:26 AM • AT&T... • 64 views • 0 helpful votes
0helpful
1answer

Hi what is the security code nokia 5220

If its from Nokia try 12345 or 00000. If it comes from SIM card, see the card manual or contact your provider.
2/3/2011 10:31:05 AM • AT&T... • 21 views • 0 helpful votes
0helpful
1answer

My cordless phone's "you have

power off base, unplug it from wall power and wait for about 1 hour. this should reset it and clear that false alert of voice message. you may post back for a followup
12/20/2010 10:55:30 PM • AT&T... • 43 views • 0 helpful votes
1helpful
1answer

My cordless phones crackle

Do you know what frequency the phones operate on? Many devices can interfere with cordless phone signals, including wireless routers, Bluetooth devices, and even microwaves.

Try moving the phones away from any of these devices and see if that helps. If you use DSL for your Internet service, make sure you have placed filters on all of the phone lines that don't go to the DSL modem.
8/9/2010 2:13:13 AM • AT&T... • 648 views • 1 helpful votes
6helpful
1answer

Our system E5947B has 4 phones - three of which

try removing the batteries from all of the hand sets.wait 30-60 seconds. 1 by 1 replace the batteries and place them on the main base. this will re-register the phones 1,2,3 etc. as you plug them into the base, they will be numbered sequentially
4/11/2010 2:51:39 PM • AT&T... • 913 views • 6 helpful votes
0helpful
1answer

How can I access the owners manual for a model

Hi,

You can download the owner's manual in PDF format by clicking this link.
  • You'll require Adobe PDF Reader installed on your computer to view the manual. If it is not already installed on your computer, download it free from: http://get.adobe.com/reader/
Hope this solves your problem. Thanks for using FixYa.
6/3/2010 7:45:21 PM • AT&T... • 121 views • 0 helpful votes
96helpful
3answers

Load default Delta file message

Problem My handset displays either LOAD DELTA FILE or LOAD DEFAULT DELTA FILE. What should I do?
Solution(s) Tip 1 of 2
If the handset is not responding normally, you may need to reset your telephone system. Complete the following steps to reset the telephone system:
Step 1: Disconnect the power to the telephone base.

Step 2: Disconnect the handset battery.

Step 3: Wait a few minutes and then reconnect the power to the telephone base.

Step 4: Reconnect the handset battery

Step 5: Wait about one minute for the handset to re-establish a link with the telephone base and then test the phone again.
11/16/2009 2:32:17 PM • AT&T... • 8,116 views • 96 helpful votes
39helpful
1answer

What do I do to clear the LOAD DEFAULT DELTA FILE

I disconnected the battery, waited a few seconds, reconnected the battery and set it on the charger. Working great!
12/21/2009 6:14:44 PM • AT&T... • 2,496 views • 39 helpful votes
0helpful
1answer

My neighbors AT&T cordless phone with two

If the other phone works fine, then it's probably the base of your neighbor's phone that is the problem, that's why neither handset will work when placed on the base. If you can take the base apart, you can blow some compressed air into it to remove any dust buildup, and check to make sure all of the connections are secure.

If the phone still won't work, do the lights come on to let you know the handsets are charging when you place them on the base
3/25/2010 12:57:45 PM • AT&T... • 112 views • 0 helpful votes
1helpful
1answer

My cordless handset is flashing a message. I get

Hi, this is a common problem with cordless handset showing "load default delta file", this is what i did to mine and it worked fine. I disconnected the battery, waited a few seconds, reconnected the battery and set it on the charger, the dial tone was back and the message disappeared. Working great!
2/8/2010 9:43:42 PM • AT&T... • 202 views • 1 helpful votes
0helpful
1answer

Callers get busy signal, all 3 phones say

Possible causes:
1. Another phone is off-hook besides these 3.
2. Bad house wiring - call the phone company.
3. Bad wiring somewhere between your house and the Central Office - call the phone company.
9/14/2009 10:09:41 PM • AT&T... • 425 views • 0 helpful votes
0helpful
1answer

Multiple beeps when phone turned

You have messages on your 'phone service provider' message system. Call your own number and follow prompts to listen to and delete messages from inbox. If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c
9/10/2009 3:37:59 PM • AT&T... • 32 views • 0 helpful votes
Not finding what you are looking for?
AT&T 650530003417 Cordless Phone Logo

125 questions posted

Ask a Question

Usually answered in minutes!

Top AT&T Lands Phones Experts

Cindy Wells

Level 3 Expert

6688 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

k24674

Level 3 Expert

8093 Answers

Are you an AT&T Lands Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

AT&T Lands Phones

  • AT&T Lands Phones

Most Popular Question

load default delta file message

  • Lands Phones
Loading...