Top 20
AT&T 1818 Corded Phone - Page 3 Questions & Answers
I bought a new AT&T 2300 to go with my
possible that the new hand sets are not compatible with the base as it requires same hand sets as the base for the base to be able to register the handsets
follow the user manual to see if there is a how to register section that will help identify the problem
1/30/2018 11:51:02 PM •
AT&T Lands...
•
78 views • 0 helpful votes
How do i deregister an orphaned AT&T TL92273 handset?
- Press and hold handset locator on base station until 'in use' light comes on.
- Press # on the handset and the phone registers itself to the base station.
I repeated the above procedure with my two remaining handsets and now I have a 6 handset cordless system for my home.
It's important to note that if you have a working base station you should use the standard instructions for deregistering the handsets. Each handset gets allocated a handset number by the base station, if you deregister using the special code detailed in this post then the reserved handset number on the base station is consumed and cannot be reclaimed; thus reducing the number of handsets the base station can support by 1. The special code is only for use when you have a handset that is orphaned from a lost or non-working base station. www.apparelstore38.com
7/14/2017 1:33:21 AM •
AT&T Lands...
•
111 views • 0 helpful votes
At&t dect 6.0 all 4 handsets say no line
check base unit .
Check phone line is plugged into base and wall
Check base unit has power going to it
If it all looks ok try plugging a normal landline phone into the base unit locations phone line to see if there is dial tone .
1/28/2017 9:31:46 PM •
AT&T Lands...
•
108 views • 0 helpful votes
How do I register new handset for AT&T cordless phone el51359
1. To de-register the orphaned handsets from their old base:
When the orphaned handset says "Connecting..."
enter *331734 [menu]
and it will soon beep and display "Not registered"
2. To register the new handset to your base:
press the "Handset Locator" button on the base and hold
it until the "in use" light comes on ( ~ 4 seconds ),
then release the button and set the new handset into
the base phone cradle. After ~ 30 seconds it will beep
and display "Handset #" (next in sequence).
3: Note: the base handles a maximum of 12 handsets.
If your system was fully populated ( ie, a handset is
already # 12 ) you will have to clear all the handsets
from the base and re-register them all in sequence.
( it is the only way to 'rescue' the places occupied
by the lost handsets ).
To clear the base of all registrations:
1. Press and hold the the "Handset Locator" button
until the "in use" light lights and then starts to blink
( ~ 10 seconds ), release the button --
then press it again briefly while the "in use" light
is still blinking.
2. The base will beep and all handsets that were registered
will display "Not Registered"
3. Follow the instructions above for each handset
in turn to re-register them:
press "Handset Locator" ~ 4sec ( in-use light on ),
set handset into the base cradle, etc.
The manual is available from:
www.manualslib.com
but does not fully describe these procedures.
Good luck !
12/30/2015 5:44:09 PM •
AT&T Lands...
•
757 views • 0 helpful votes
Not finding what you are looking for?