20 Most Recent
General Electric Stove/Oven/Range Chrome Timer Knob Set - WB3X459 - Page 5 Questions & Answers
Hotpoint self cleaning oven won't heat
maybe a bad connection with the heating element. Check to make sure bottom element is pluged in all the way. May need to be replaced if anything looks strange (ie. burnt spot, hole, srrange color, or maybe no external sign)
Oven wont turn on and f7 keeps beeping, but stove
Hi there,
Well, F7 error code occures due to
A = Function pad button stuck or
B = Bad clock Unstick button or
Replace Electronic Range Control (ERC)
Replace the ERC there are ten screws 3 on each side and 4 on the control leave the hex screws alone all you need is a phillip screwdriver.
REMEMBER TO SHUT OFF THE POWER FIRST lift and fold out the control panel remove the ribbon cable and remove the four screws that hold the control board . replace control panel in reverse order.
Good Luck!!
Have a nice Day!!
Thanks
Oven doesn't light, ignite
I assume it a gas operated oven. In the past I have gotten the gas company out to reajust our stove at no cost. If it is a gas unit you need it readusted before it cause damage to your house or life.
GE oven ignitor replaced, gas turns on but no flame
Yeah, blowing up the house is never a good way to replace an appliance :)
Try contacting GE at: http://www.geappliances.com/service_and_support/contact/form_service.htm. It should be free and they'll be able to help you narrow down what's going on.
Alternately, new GE ranges start at a little over $400 at Home Depot... You certainly have to appreciate keeping a good appliance going, but if it starts nickel & dimeing you, it may be that range's time to go.
Turn up pilot light
The ajustment screw to increase the intensity of the piolet flame is located on the oven gas valve(behind the cntrol knob.
When on "bake" the top
I do not think yoy have a problem as most ovens operate off of the bottom element only. The top element is for broiling only.
Cooker hood
Look around on the hood and cooker for a small fuse. If you find one, replace it with one of the same type and rating.
Replacing oven burner element, the lower element, for a GE stove
> (I think it is 50 watts or volts??)
Most electric ranges are supplied with 220 volts - this is, especially at 60 Hz, deadly.
You were lucky this time.
If the wires are not welded onto the element contacts, they might be so-called 'quick-disconnects' that pull straight off of blades that are part of the elelment.
You probably haven't hurt the range with the momentary short circuit since the chassis of the range is connected to neutral or ground so you just gave your breaker a workout.
BTW, I have had to replace late breakers after they tripped. They wouldn't stay reset any more even after the problem was removed from the circuit.
Don't be surprised if yours doesn't stay reset; it may not be a fault causing it.
Not finding what you are looking for?