20 Most Recent General Electric Clothes Dryer Knob - WE1X1208 Questions & Answers

Take it apart ... insert vacuum hose... also clean vent where it exits house If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

http://waterheatertimer.org/How-to-wire-240-volt-outlets.html Usually there are 3 screws in a row. The cord has 3 wires in a row. Connect either outside wire to either outside screw. Connect center wire to center screw. Look at type of plug on cord. Gene h If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

my ge dryer working but the clothes is wet and dryer is stoped wieh in 7 miniute

try and glue it or just buy a new one. sounds like it was made in japan

sounds like a bad cycle timer switch

timer needs too be replace might have dead spot inside timmer.

I found my manual...simplified version: 1) On the panel - press the manual button 3 times until Auto is lit - the remote can now be used 2) press on - on the remote 3) press the desired time (2, 4, 6 or 8 hours) on the remote 4) press repeat on, on the remote Timer should be set!! =) Pressing auto off wipes out anything that was programmed!! Pictures attached!

You will get one on eBay uk

http://waterheatertimer.org/How-to-set-timers.html Link above shows hot to set analog timers Gene Water Heater Timers Save Money If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7