No problem on this one. Turn of the valve to the toliet just above the floor next to or behind the toilet. Go turn on a outside faucet. Is there still pressure? Wait a minute if it seems like there is still pressure to let the line pressure go down, what this is just water in the line left over. If the water stops on the outside faucet then the water is off. If you do not have a outside faucet then use a tub or a sink faucet. (if it does not stop then see part 2)....Keeping the toilet valve off remove the supply line from the toilet where it connects. This sould be the larger end. Is it is a flex line this should make it easyer. If it is a hard line like copper tubing, stop and go to the hardware store and a buy a flex supply line. This will make your job a lot easyer. After you remove the part of the line that connects to the bottom of the toilet then find a bucket place the end of the line you removed from the toilet into the bucket ( you may have to place the bucket at an angel to do this. Now turn the water valve at the wall for the toiel back on and drain the line. You may have to empty the bucket a few time but the line sould drain out.
( Part 2) If the water to the house is still on you need to go to the water meter and turn of the curb stop, this is going to be the valve inside the meter box ( if you do not have a well) and are on public water. You will need a cresent wrench, sometimes these valves can be hard to turn so you may have to use a little force. If you are on a well the you need to find the valve in you well house and turn it off. If you need more help or this did not solve this problem the repost and I will check back in a little while.
Usually happens when the stops and not ballanced(hot and cold pressures going to the faucet). Try ajusting the stops; open more on the hot or close more on the cold.
If it is leaking around the handle, the cartridge may be loose and you need to tighten it more. If it is leaking from the spout, the cartridge is faulty. Even if you bought a new one, it may be faulty. They are made in China and the quality control is awful.
Question edited for correct spelling of maker 'Noen' to 'Moen'.
'Fix' as in it is leaking? Or tighten it down because it is wobbly, or something completely different?
Well, we can have a one on one seminar by the internet. I've been a pumpman for 20 years. I can share with you my experience (household pumps, suibmersible pumps, turbine pumps, gear pumps, piston pumps, dewatering pumps, mud pumps, trash pumps, mining pumps, solids handling pump, etc....) Just take your pick. Just send in your e-mail for assistance. God bless.
It is leaking due to a defective mechanical seal. It needs to be replaced. To replace it, is to take the pumpcase off by taking off the bolts that hold it. Then, take the impeller off to take the mechanical seal behind it. Put the replacement in, and reassemble the pump. Just get in touch with us by e-mail to get more assistance.
Move the lever or turn the knob. Check the stop tap under the sink. Make sure the faucet control knob or lever is tight, There is normally a removable cover that hides the screw..
Question edited for clarity, full 'make model (what it is)'.
This a Menards special. To remove handles, look for a small hole hidden from the front. They take a small Allen Key.
