20 Most Recent
Moen 7840 Camerist Single-Handle Kitchen Faucet with Side Spray Chrome... - Page 7 Questions & Answers
I just had a plumber install new moen faucets in my bathroom sink. After he left, I discovered that there is a slow drip. These faucets are brand new! What could be wrong?
well it can only be 1 of 3 things, 1st can you tell if it is hot or cold water dripping?? 2nd is the handle loose can you wiggle them and 3rd how old is the faucet I know you said it is ''New" but it could be "old" stock from his shelf in which case the gaskets/O-rings could be dried out and needs to be replaced...
if loose then on top where the "c" or "H" is that cap comes off using a finger nail or small knife point pop off caps under caps there is a screw remove it but first turn off water under sink you will a bigger nut use a adjustable wrench to snug it more then try again if still leaking remove that big nut the is a washer on the bottom that will be leaking there are many sizes so you will have to buy an assortment with mixed sizes fond the two you need remove screw on bottom put new one in,,, put it all back together...
ps if you have vinger you can soak old washer but this only short term fix, replace washer
How do you tighten the handle on Moen 7594E
There is a plastic button on the bell of the handle right by the base of the lever. It might be blue and red for hot and cold or it may be the same finish as the faucet. Remove the plug and tighten the allen screw. It takes a 3/32" allen key. If this doesn't tighten it adequately, you must remove the handle, and gently tighten the plastic retaining nut with an adjustable wrench or a channel lock pliers. The adj wrench is recommended over the pliers.
How to tighten a Moen Anabelle CA87003SRS single handle kitchen faucet to sink?
Shut off the water
Clean and dry the area around the faucet.
(
from the bottom)
Disconnect/remove the faucet (clean or replace gasket).
Clean the hole completely & apply desired sealant
Positon the faucet in the hole & TIGHTEN (firmly).
Reconnect water lines & restore water supply.
(do
NOT over-tighten).
Place clean "printer" paper under each wall valve & supervise
for several days to assure no DROPS are leaving wet marks on the paper.
Be proud.
Carnac the Magnificent
I RECEIVED FROM moen a replacement cartridge for my faucet model 7570. how dopen the faucet as to replace the cartridge/
There is a red and blue button on your faucet handle. Remove it and use a 3/32" allen key to remove the handle. Remove lever handle adapter assembly to gain access to cartridge. Retainer nut must also be removed. Pay attention to the position of the notch on the brass part of the cartridge. The notch on the new cart must face the same way. Have fun reassembling because it's not fun. I suggest you take pics every step of the way because you THINK you will remember, but that isn't usually how it works out. Good luck!
Not finding what you are looking for?