20 Most Recent
LG 47LG50 47 in. LCD HDTV - Page 8 Questions & Answers
SKY REMOTE CODE FOR LG 47LG50
please follow the steps below:
TV
RED + SELECT (flashes twice)
TV
0056
try the volume if this works then press SELECT to save the code. If not then press TV again then the volume. repeat this step until the volume works then press the SELECT button to save the code.
cheers
Little Dish Fitter
It shuts off after warming...
when heat is turned off is
to check the power supply you may have spent filters, but also check what is the
card that feeds the reverse lamparas processors and the same panel
LG LCD from Germany - will it work in Australia
Hi There, My advice is don't do it. There is a good chance it won't work I found a bit of a description of the problems here http://hometheater.about.com/od/televisionbasics/qt/ntscpalframes.htm The differing standards have been sucked forward into the digital era. :( There are also voltage and frequency issues to think about. You may find an adaptor but it could also stuff your picture quality. Even if you can get it to work you will be on your own with Warranty. If something go wrong you may have to return it to your place of purchase. I hope this helps with your decision. Doug.
Tv works fine for few minutes, then the tv wont respond to remote
There's clearly a heat-stressed component in there, possibly something as simple as a badly soldered joint in which a gap opens up due to heat expansion.
It's not that old a TV so may be covered under warranty. If not it's going to need to go into a repair centre where they can find the fault and repair or replace the affected part.
Re-soldering a bad joint isn't always possible in which case the circuit board which it's located on gets replaced instead.
Sky code - LG 47" TV Model Code47LG5020ZB
If there is no code, then there is no code.
The only other option would be to buy a 3rd party remote that is compatible with both devices. Unfortunately there is no way to know if it will actually work until you try it.
Switch our tv to souround sound
Surround sound will come from the speakers from your surround system. So if you have it connected through HDMI 1 select that option from the source button on the remote control. If you have it connected through Scart 1 then select AV1 from the source button. It also best to turn the volume from the TV to minimum so that the sound only comes from the surround speakers.
I have a LG dvd
player 5083 inserted the disc the correct way into the draw but the machine does not play the disc a very slight humming noise is heard then it spits the drawer back out
Clean the Lens: Use a DVD cleaning disc to clean the lens. If the problem persists, consider professional cleaning.
Test Other Discs: Try playing different DVDs to see if the issue occurs consistently. If it's specific to one disc, that disc might be the problem.
Check for Updates: Make sure your DVD player's firmware is updated. Refer to the manufacturer's instructions for firmware updates.
Try a Different TV: Connect your DVD player to a different TV to see if the noise disappears. If it does, the issue might be with your TV.
The hum is simply the player trying to read the disc. It can't so, it spits it out.
Remember that prolonged use of a malfunctioning DVD player could potentially cause damage. If the problem persists, consider seeking professional repair or replacement
Not finding what you are looking for?