20 Most Recent JVC LT-32P679 32 in. LCD TV - Page 5 Questions & Answers

These blinks to standby light are fault indications, called blinking codes. From the number of blinks occur at one time switch on, you can get an idea about the faulty circuit stage inside it. Count it. Visit this site. It has details about blinking codes to many brand televisions.http://electronicshelponline.blogspot.com/Pull up older posts there, either by its left side bar, or see it in Timslide option

You may download a copy of the manual here.

replace power supply board.

That could be a main board issue or a power supply issue. I would check the power supply for the stand by voltages and see if any are missing or low

You need to select HDMI input.

If this is an LCD TV, show a flash light on the screen from a safe distance. If you can see picture, it means the backlights have gone off and the TV might need servicing.

Check this link.

what is the model number of this JVC TV?

A model number off the back might allow me to give you some real answer.

Hi!That's a clear indication that you have a bad power supply in your TV.If you know how to DiY...I suggest you open your TV. Locate the power supply section, it is where the end of the power plug is connected. Replace all blown or bulge or leaked capacitors with same value. That will fix your TV problem.The hardest part is to disassembling your TV cover, cause you will need to pry off the snap in lock at the edge of your TV.Power supply board should look like this. Examine the capacitors in the boardAfter replacing blown capacitors...it should work again.Things you will need.1. A plastic flat end screw or any object with flat ends....to fry off the cover2. Soldering iron.3. Soldering lead4. Soldering pump.5. Flat and Philip Screw6. Replacement capacitors (of same value with the blown one) that you can buy to any electronics store.Hope it helps

OK i would check the obvious first. Check your controls to make sure the speakers are turned on. The next thing I would check is your speakers you would have to take them out and inspect them physically and if you can take the out and plug them into a receiver or something that has oudio out. If all that is good then You signal board migh be bad.You can get parts for that tv at www.interliquidparts.com