20 Most Recent
RCA M4204 MP3 Player - Page 2 Questions & Answers
My rca opal mp3 player freezes on the screen where it says initializing when i turn it on?
Go to "http://voxrightnow.custhelp.com/cgi-bin/voxrightnow.cfg/php/enduser/std_adp.php?p_faqid=2559"
To update the firmware of the M42xx
mp3 player click here and
download the firmware. start the firmware and when it is runnin plug the M42xx in at the same time holding down the PLAY BUTTON (center) until a white screen with a small
computer with a line going to your M42xx is displayed and then release the PLAY button. You can then click on start and the firmware update will complete,,, DO NOT DISCONNECT DURING THIS UPDATE... it may take 2 times to complete this but it will work.... YEA!!!! WORKS with 2, 4 or 8 GB Models.....
It doesn't play anything, only stores the MP3
hi, If your deleted the diver then try to update the firmware the player. To update the firmware on your RCA M4204 MP3 Player, you will need to:1. Connect the player to your computer prior to installation.2. Open the below added link3.Click on the Firmware Update/Restore Utility link.4.Select "Save" and then select the desired folder to save the installer to.5.Run the downloaded installer and then follow the instructions to complete the installation.The firmware and other softwares are available in the bellow added linkhttp://www.rcaaudiovideo.com/downloads/?sku=M4204If you need any more assistance then feel free to contact me by fixyaOK
Where can i get music
Most mp3 are compatle with mp3 player. I download music from bitcomet, winmx, filetopia, once the mp3 is plugged into the usb of your computer open the music folder and drag and drop the mp3 file there.
I have the 4204-A and it is stuck on one song. I
Thier should be two small holes on the player probably on the back one is the microphone the Other is the reset switch. Mic should be labled. Take a straightened paperclip and gently press it
in the hole and the paperclip shoud press a switch on the inside of the player to reset it.
My mp3 seems to be
There should be a small hole somewhere on one of the sides of the device, small enough that only something such as a needle or a paper clip can fit into it. use a small item to press the button that resides in this hole. Most modern MP3 players have this small hole and its a basic reset function for the operating system that runs the MP3 player. Also you may want to try updating the firmware on your device
here
My mp3 player will not
It is likely that the battery has given up. If there is no response from the player, you could contact RCA to see about repair, but it may be cheaper to buy a new MP3 player.
Usb port broke and missing which doesn't turn on,
You can buy a new USB female connector and solder it on the PCB of your MP3 player.
You will need a female Mini-USB Type B connector, a soldering iron with a fine tip, flux and some solder wire.
1. Open the case of the MP3 player and look for the spot the lost USB connector was soldered on.
2. Clean the pads with a cotton swab and some clear alcohol.
3. Clean the female USB connector using the same method.
4. Heat up the soldering iron to a moderate temparature.
5. Put some flux on the solder pads.
6. Place the female USB connector on the pads and solder it on by touching the soldering iron and the solder wire on the pads until a tiny drop of solder makes the connection. The solder should flow on the pads because of the flux.
7. Re-assemble the MP3 player.
You can then test the connection using a multimeter.
Good luck!
Not finding what you are looking for?