20 Most Recent American Standard Contemporary Kitchen Sink Liquid Soap Dispenser - 4305.20... - Page 4 Questions & Answers

It's possible you installed the valve upside down, all values should be labeled in some way marking either hot and cold or it will say the word up where the riser tube port for the shower head is. If that's not the case remove the tub spout and check for any obstruction sometimes during tile or constructing debris can get into the pipe for your tub spout. Lastly the diverter on the tub spout could be bad. Try a new tub spout

Trey, motor or pump is seized, have tech. take a look and repair.

1. Turn off the water at the shutoff valve, flush the toilet and hold down the handle. There may be a little water left in the bottom of the tank, but don't worry about it. Wipe the flapper seat with a clean cloth to make sure it's free of debris, and check it for cracks or splits (Image 1).

   How to Fix a Leaking Toilet ' how-tos ' DIY

   www.diynetwork.com/how-to/.../how-to-fix-a-leaking-toilet DIY Network
   Feedback

How to Fix a Leaky or Runny Toilet - This Old House

www.thisoldhouse.com > ... > Toilets
This Old HouseA toilet that leaks or runs is an easy homeowner fix-if you know how to diagnose the trouble. ID parts and problems with this handy guide, and hit the hardware ...

page tite

General Plumbing Supply has always come through for me... Yelp only gives them a 3/5 but I have always had to wait with PROFESSIONALS to get my turn. I'm not big on ambiance when hunting for obscure plumbing parts.. BRING your old (always... any-parts) seat with you! Amazon says $34 (plus tax)... Phenomenal return policy A quick search on line yielded lots of other choices... Happy hunting!

Change the flap in the flush container.

The new toilet has more flushing volume than the old one. The system should handle this. The problem could be the vents on the roof are plugged or something in the line is obstructing the flow. You will need to contact a plumber

This is called air hammer, most times this is caused by vibration when a water pipe is too close to a support board you can put in a hammer arrester or make sure pipes are away from support board .

This can answer only by checking the system. Call another plumber.