20 Most Recent LG LRSC-26922 Side by Side Refrigerator - Page 2 Questions & Answers

http://www.scribd.com/doc/104030001/LG-Service-Manual-LRSC26922xx-S-M

In order to determine the problem you must check a few things:1) Is there water in the ice tray? If not. verify the saddle valve is turned on, check the connection on the water valve, verify that there are no kinks in the inlet hose, and check he water filter to see if it is clogged.2) Is the temperature correct? Make sure the fans are working properly and air is flowing. Verify the the frig and freezer are at the correct temperature and make sure the ice maker compartment door is sealing shut.If these things check out ok, run an ice maker test. Make sure the ejector arm and feeler arm are in their original positions before beginning. If they are not:1. Turn off icemaker and wait 5sec. 2. Turn on icemaker. 3. Wait until feeler arm and ejector are back to original positions.To begin the icemaker test: Press and hold the test button on the icemaker for 5 seconds. If the LED, feeler arm and or ejector does not return to to their original positions the problem is with the ice maker. The ice maker part number for your model is 5989JA0002G

The water line is freezing in the door due to deteriorated insulation. The only fix I have found to work on my fridge was to defrost the inside door with a blow dryer. Then place a weedeater replacement line (the orange 10" or so size you find at Lowes' or Home Depot) up through the dispenser nozzle, If the line only travels about 3-4 inches up the nozzle, then ice is still in the tube. Blow dry it until you are able to get water to dispense. After the tube is ice-free, place the weedeater line up throuth the dispenser nozzle leaving about 1/8" sticking out. The dispenser will still work with the line stuck in it. The dispenser will probably freeze again in about 8 hours, But all you need to do each time this happens is to pull the weedeater line out, dispense the water to unclog the ice, and place the weedeater line back in the nozzle. I have been using this method for about a week now and it works great. My GE Side-by-side is also 4 years old and this seems to be a problem with all of them. There is a part you can order to fix the problem, but I have heard it may not work.

You can use a blow dryer. However if it is freezing up you have a bigger problem. Freezers actually go thru a defrost by use of heat elements in the wall of the freezer. This is where the water comes from that drips in the bottom drain pan. Have a technician replace the element.

Check to see if hose is stopped up.

do you have direct water feed?if so check feed

Have you replaced the water filter lately? Here is the OEM filter for that unit.

First, make sure you have water going into the refrigerator. Then check the one in two out solenoid controlled water valve (first place the water line connects). If you put a voltmeter on the solenoid controller, you should see a voltage at the solenoid. If you do, then replace the solenoid controlled water valve, if not then follow the electrical line back and see where you lose the signal.

so two things I have learned. First if the tabs on the funnel break dont buy a new one just crazy glue back in place. Also if you take the gasket out put vaseline on the nubbins and they will slide back in place without having to take the panel apart. Fix time 7 minutes. Booyah!!!