20 Most Recent
Black & Decker CD9600SBGB 9.6 Volt Drill With Gift Bag [Misc.] - Page 5 Questions & Answers
Drill wont take a charge
9 times out of 10 problems like this are the result of a bad battery, in other cases it can be a bad charger. Without knowing more information I cannot give you an exact diagnosis. This is the first question I ask when approached with this issue, Has this drill been sitting for a period of time and if so, was the battery charged before it was put away? If Yes, the drill has been sitting and No, it was not charged are your answers than chances are your batteries are dead. This tool has Ni-Cd batteries that self discharge as they sit, eventually these batteries discharge until they have nothing left. In addition, if the battery is stored in a cold garage/shed will speed up this self discharge. I always tell people to think of their power tool batteries just lie a just like a car battery that dies if it sits too long without being started.
If you do not use your power tools on a regular basis it is recommended to fully charge the batteries before storing them or else they will self discharge until completely dead. Another option is the newer Lithium-Ion power tools batteries are not as temperature sensitive, have a much slower self discharge and can sit for 12-18 months before starting to loose their charge.
A replacement battery for this drill runs about $42 plus s/h and can be purchased directly from Black & Decker (1-800-4-DeWalt or www.dewaltservicenet.com) My recommendation is to purchase a new drill. For around $40 - $50 you can buy a newer upgraded model with new battery and charger.
If you think your issue may be something else, please feel free to ask. If you feel I have helped explain or resolve your issue than please rate me. Thank you
Can't remove the chuck on a drill.
There are one-way (non-reversible) and two-way (reversible) drills. Mine is one-way. Methods for chuck removal are different for these two types.
Procedure for one-way (non-reversible) drills:
Drills of this type have no chuck screw, so one have to hold the spindle with a wrench, than to sharply strike the wrench with a hammer to spin it off.
Procedure for two-way (reversible) drills:
Open the chuck up and in the bottom is a screw that holds the chuck on
the shaft.The screw turns in a clock wise motion to be removed and then
you can top the chuck off the shaft.
I have a B&D Firestorm 18v 1-hour battery
Hi I have same problem with the charger. Solution is to replace the charge with new part number issued from B&D AustraliaNumber of 90515050-01 until stock runs out , then it is replaced by part number of 90578873 early to mid june 2013.Hope this helpsLance from Perth , Western Australia.
Not finding what you are looking for?