20 Most Recent Black & Decker CD9600SBGB 9.6 Volt Drill With Gift Bag [Misc.] - Page 4 Questions & Answers

usually an allen wench

OMG!!! "It" doesn't Loosen?! Does it Listen? LOL. OK enough! I have had these BD drills before, and sorry they are JUNK! You would REALLY be better off by purchasing a Craftsman Nextec 12 volt drill. It is Lightweight, smaller for small hands, has a flash light built in! AND in a set comes with Cool Flashlight that stands up. It comes in a bag with a charger for $50! BD has NOTHING like this! OK I have HILTI drill ($300)! I never use it cause I use the heck out this great little Craftsman drill. OK solution to your drill bit problem...EASY. Go and buy some WD-40 in the blue-yellow can ($4-5). Spray (ALOT!) around and under where the bit is and where the cap that spins is. Do Not spray into any vents! It May catch Fire. Let it soak x 15 min. Spray a little again. Then Grab a terri cloth towel wrap it around the cap that spins and the bit and reverse the motor to loosen the drive. Be sure to have the drill on Max setting (the drill bit icon). It WILL come off. If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

Well I couldn't find a pix of your drill so I will guess that it is a typical drill. You seem to be asking a very basic question so I will start will all the basic info I can think of.

First you have to know where the power trigger is to make it go.

2nd you have to know where the forward and reverse switch is.

Now with the switch in the forward position squeeze the trigger to make it go. Then gently grab the chuck with your hand while it is going and the center Jaws should close up and come out of the chuck.

Now with the switch in the reverse position squeeze the trigger to make it go. Then gently grab the chuck with your hand while it is going and the cetner Jaws should open up and go into the chuck to a maximum point

Open the jaws enough to put the drill in the jaws then put the switch in the forward position. Put the drill in the chuck, sqeeze the trigger to make it go, and hold the chuck so the jaws close on the drill. All while keeping the drill from falling out of the chuck.

When it closes on the drill and the drill is in straight then hold the chuck as tight as you can while squeezing the trigger to make the jaws close very tightly on the drill. If you have very tender hands you might want to use gloves.

To get the drill out put the switch in reverse, hold the chuck very tightly, and squeeze the trigger to open the jaws off of the drill.

Not without a special switch an some wiring