Top 20
Stanley Professional Backpack Poly 4-Gallon Sprayer #61804 Questions & Answers
Stanley backpack sprayer top is stuck....... how do I get it off?
Hi Chris:
Seems a bit extreme to consider using the 12 gauge. I've found that a .22 works quite well. (Humour)
Hint! Pressurized tanks must have the pressure relieved BEFORE the lid can be removed.
If the lid has been over tightened or has stuck, you'll need to get more leverage to unscrew it. Sometimes a rag wrapped around it is all it takes.
You can also try pouring hot water over the cap. Lay the tank flat so the rim of the cap gets the heat. Wrap an old towel around it first so it gets a good hot soak.
Should come off without the artillery.
Cheers
3/19/2016 6:06:31 PM •
Stanley...
•
2,095 views • 0 helpful votes
I need a new rubber
Drive out to the country side and look for a ACE or TrueValue hardware store. Bring your sprayer with you. They will likely have the right part for you in stock.
9/9/2011 3:28:37 AM •
Stanley...
•
1,774 views • 4 helpful votes
I have a Stanly backpack sprayer pro 61804n and
The picture looks a lot like a Solo sprayer I have. I wouldn't be surprised if Solo made them for Stanley. Do a search for Solo sprayers. They have a site. My sprayer is a Solo 425
6/21/2010 11:30:37 PM •
Stanley...
•
1,646 views • 2 helpful votes
MY STANLEY 61804 DOES NOT PUMP. THE PUMP HANDLE
the darker Seal has come off the plunger at the bottom of the unit , easy 5 min fix , just unscrew the allen keys at the bootonm take off the cover and remove the plunger , you'll see the plunger seal still inside you can fish it out with an allen key or similar tool clip it on again and reassemble
10/29/2009 10:25:59 PM •
Stanley...
•
1,443 views • 7 helpful votes
Stanley P1800S pressure washer lost pressure after a few uses
The valve-o-rings + [ parbaks seals ] where the pressure can be adjusted with.
Control the water inlet filter or hose that there are no waterlock couplers are used or is mounted
on the wrong site on the hose , that it is used as water inlet on the tap.
How do I get the top off? STUCK!
Hi Chris:
It is usually easiest to rest the weight on the tailgate of a pickup truck (or some other device) and then slip out of the harness.
Another technique is to lift bend forward while at the same time rising one shoulder and lowering the other. That will create "slack" on the low shoulder side allowing you to get that arm out.
Cheers
What is the lance o ring for
If you switch the unit on and water spits out of a connection, that's where you either put the O-rings or replace them.
The stanley garage door opener Model 3220.51 is
If it is a screw drive like mine all I needed to do was lube up the screw with a product called "fluid film" and all was ok. The screw was binding making the sensor think the door was blocked and it would go back up.
Not finding what you are looking for?