20 Most Recent
Stanley Professional Backpack Poly 4-Gallon Sprayer #61804 - Page 7 Questions & Answers
How do I snap off
The safest way is to put on safety glasses,extend the blade to just beyond the next line, grip the blade with a pair of pliers at the line with the edge of the pliers parallel to the line and give the pliers a twist. The blade will break off cleanly.
Nail stuck in the tip
The owners manual should have instructions for freeing a jam. Nomally removing the two allen bolt in the front cover them the two bolts that hold the guide plate will allow access to the plunger and the jam.
How do I change the
Hi, W/D here.
The blade changing is accomplished by pushing the yellow button and pulling the old blade out. It is reversible. If there is no blade at the ready, there may be more in the body of the knife, which are located behind a swing out panel on the handle. You'll need to push in the yellow button when installing the blade, and once the blade is in, release the button, and moge the blade until it clicks in place.
--W/D--
I purchase a stanley 450
the most simple way to run the radio from a charcher is to hook radio and charger to a battery
the charger will charge battery and battery will supply constant volts to run radio
Need drawer gliders for red
You forgot to include the manufacture of this tool box which is needed. The catagory used as showing is for a chain saw instead
How to put batteries
The lower part of the plastic foot on each tripod leg just screws off. Change just one cell at a time so you don't get confused which way the cell goes in. Use alkaline cells, not zinc-carbon which tend to leak. Good luck!
How do i insert the
Cut the end of tube on a angle.There should be a rod with what looks like a plunger at the end.pull the rod back as far as it will go and lock into place.slide tube of caulk into gun with open end of tube towards the plunger.should be a slot at other end where nozzle fits in.take a piece of wire and poke a hole up the nozzle of the tube.release the rod and sqeeze the handle a few times you should see the rod start moving.if not turn the rod until the teeth are facing down.then try again .you should hear a clicking sound and feel pressure and caulk will begin to come out of tube and you will be caulking.Good luck.If you still have problems just come back to fix-ya and we,ll help you through it.
My garage door opener was
Hello digi..... to set the keypad you need two people. One on a step ladder to push in the button on the garage door opener motor which makes the light blink. then while the light is blinking punch in the 4 digit code and hit enter.
To set the remote, push the button on the motor so that the light blinks then hold the remote nearby and push the button on the remote.
Joe
Thanks for choosing Fixya!
Not finding what you are looking for?