20 Most Recent Jandy Aqualink - Rs24 One Touch Pool / Spa Combination Control System - Page 5 Questions & Answers

turn off aqualink then turn back on then turn intelliflow on it should see it also works with heaters

go to system set up then go to program then either edit or delete

make sure 4 pin red plug is plugged into PCB board also check to see if wire is cut

go into system set up lights highlight your lights save then turn everything offf then back on they should sync

if it is on the aqualink it is the one hoseclamped to the pipe coming from the pump if the temp sensor on the heater it is mounted to the header of the heat exchange

not required unless hooked into seats and have a blower option

change cell

go into one touch function remove what you dont want to come on

go to aqualink and put it in auto mode

make sure 4 pinred plug is plugged in all the way and not loose if ok bad controller board

shutoff aqualink then turn back on then turn heater on should be ok

go into system setup highlight time and date then change

yes it is behind the top panel board should be 9volt if newer on back of PCB board there will be a nicade battery that holds time and date