Sta Rite Sta-Rite Max-E-Therm High Effiency - Propane Heater - 333,000 BTU - Answered Questions & Fixed issues
Heater fires runs for 2min.service heater lite
This issue sounds tricky. I recommend you callthe Sta Rite technical support at 888-782-7483 and they should be able to helpyou figure this issue out.
I hope this helps.
6/6/2017 2:59:55 PM •
Sta Rite...
•
Answered
on Jun 06, 2017
•
263 views
I have a heater problem,
Have any mice been inside the heater? If so check the burner. Some times the mice will nest inside the burner and it will need to be cleaned.
5/14/2017 11:44:02 AM •
Sta Rite...
•
Answered
on May 14, 2017
•
903 views
Heater won't stay lit
could be caused by many things. could be an flame sensor error, open saftey switch, stack flue error, etc look on back of circuit board and tell me what errors are lit up
1/1/2016 11:25:21 PM •
Sta Rite...
•
Answered
on Jan 01, 2016
•
609 views
I have a hayward SR333Lp that ignites for 5 seconds and then displays service heater. No leds on back of board to indicate cause
Today's gas appliances are designed to shut off when combustion problem is detected.For example if burner parts are dirty of clogged, the gas valve continues releasing gas, but not all the gas is burned.This caused potential explosion risk, with unburned gas in the combustion chamber and flueway.Call service tech to clean combustion parts, check pilot or igniter alignment, check gas control valve, and gas pressure, and bleed air out of gas line if needed.Search internet for product manual. Product number appears on label, and then add .pdf to search parameter. If you need further help, I’m available over the phone at
https://www.6ya.com/expert/gene_9f0ef4df2f9897e7
12/3/2014 10:16:11 PM •
Sta Rite...
•
Answered
on Dec 03, 2014
•
301 views
Error code E006
Eo6 is the error code for stack flu sensor/switch. It threads into the exhaust pipe on the heater. Replace it and youre good.
8/13/2014 4:18:00 AM •
Sta Rite...
•
Answered
on Aug 13, 2014
•
1,469 views
ERROR CODE E71
What is this error code? do you have any legend? this has no specific error codes as listed.
6/7/2014 6:07:25 AM •
Sta Rite...
•
Answered
on Jun 07, 2014
•
172 views
What part needs to be replaced?
display board runs on 24 volts. make sure the secondary side of the transformer is putting out 24 volts. if the control pad is getting proper voltage and it doesn't work, replace the control pad and board
5/31/2014 2:55:51 AM •
Sta Rite...
•
Answered
on May 31, 2014
•
92 views
E05 code
e05 error code means shorted stack flu switch or sensor. oder heaters have the switch, newer heaters have the sensor. make sure you know which one you have before ordering a replacement.
4/14/2014 1:32:07 AM •
Sta Rite...
•
Answered
on Apr 14, 2014
•
1,754 views
Not finding what you are looking for?