20 Most Recent Dream Maker Spas Dream Maker Ez Spa Hot Tub - Page 9 Questions & Answers

Hi Debra, That sounds like barrings, so you will need to have a tech out to repair or you can remove the pump and take it to a local small motor repair shop which is sometimes less expensive.

Tannins which is water that has organic material from decaying foliage can be a bit of an issue with your equipment especially the filters but for the most part is an aesthetic issue. The only way to remove the tannins is pre-filtering before you put the water in the hot tub. You can purchase a purestart pre-filter you attach to your hose when filling your hot tub. If that does not do the job there are some applications from MetalTrap that may aid you as well. If all else fails you may have to look into something more industrial like Tannin Filters Tannin Filter Systems Remove tannic acid color from well...

Did you make sure you observed the correct polaity on the cord? The white wire should go to the silver screw on the cord cap. The black wire should go to the gold terminal (brass) and the Green wire should go to the Green screw. If the plug was corroded, is it possible that the GFCI is also corroded? They aren't that expensive and you could replace the GFCI yourself if you're sure you can locate the circuit breaker and turn it off.

Bad Jets button on the topside controller panel - need new panel

Bad button on the topside panel.

During that 15 seconds, do you see the water moving in the spa? If not then normally, that means the pump has not primed fully - hence the 09 Error Code. Pump could have a clog internally, but most likely problem, Dirty Filter.

i would drain the whole thing down and run a hose into whatever hole you think it might be in and try to back flush it,....the more pressure from the hose the better. good luck

what voltage are you getting to the circ pump? if circ pump is gettin proper power... motor windings or capacitor may be shot