20 Most Recent Milwaukee Tool Milwaukee Orbital Jig Saw with L.E.D. 6268 - 21 Questions & Answers

High Speed Steel - Used for wood and light metal cutting Bi-Metal - Also used for wood and light metal cutting. Cobalt Steel - Tougher and lasts longer than Speed steel and Bi-Metal. Used for wood and metal. Carbide Grit - Strictly used to cut masonry board. Scrolling - Thinner than the regular jig saw blades and are used for tight turning cuts.

THE RED PART TO CHANGE BLADE WILL NOT MOVE

When you get the next email, at the very bottom there should be a link that says "unsubscribe". Click that and you will be good to go. I hope this helps!

Yes the Milwaukee 6268-21 does require the use of certain jigsaw blades. You have to use T-shank type blades. You push the tension lever hold it while putting the blade in as far as it will go, then you release the tension lever slowly and it will engage the blade. You should then check by pulling on the blade to make sure it is seated properly and will not come out.

The blade lines upaccording to the rotor shaft and has nothing with the guide except for the fact that the table has been droped and bent out of place or has been tweeked out of place somehow, usually hitting the floor from the table top causes this. Loosen the table screw to see if you can get it back in place and square it back up, hope this helps, good luck!

a new tool will cost you about 170. You could look for a used on on craigslist.