20 Most Recent
Singer 8763 Curvy - Page 3 Questions & Answers
The light doesn't come on
If it doesn't come on, it's probably burned out. Before you replace it, though, tap the area a little; sometimes the bulb can get a little loose in its holder. Your machine's manual will show you wish bulb to purchase, and how to replace it; you don't have to take the whole machine apart to do that. By the way, those machines don't take a wide variety of bulb, and they're commonly available. You might try Sewing Parts Online, especially if you can't find your manual; they also have manuals available as well.
Sewing then beeing then jamming up
The Beep is an alarm telling you to stop sewing and find the problem. Since it is jamming in the bobbin area, you should start there. Remove the fabric, then remove the bobbin and bobbin carrier... clean and remove any stray bits of thread from the bobbin area. You also should examine the needle or change it as a matter of course.
Needle position
Please correct down position and remove the foot and switch off machine. Then set of the up position applique the needle. After machine On.
My stitches are to loose
Generally loose stitches often means you forgot to lower the presser foot. It's really easy to forget when you are sewing thicker fabrics. Barring that it sounds like your tensions need to be adjusted. Try to remember "loops on bottom... tighten top tensions" "Loops on top, loosen top tension."
Light won't come on
Try changing the light bulb. Your sewing machine manual will probably have instructions on how to do this.
Needle wont catch bobbin thread. Think timing is out.
First change your needle... it's probably bent and make sure you are using a needle FOR Denim in a size 18. Hand run the machine... if you still feel it hitting something... it is out of time. Take it in for repair.
I have Singer Curvy 8763.
I be s 8763 was sewing beautifuly, took off pressure foot to make a buttonhole read the manual followed directions button holer kept gumming up with thread and the alarm kept going off, then got flustrated, put back on the sewing pressure foot now it is like the needle is out of line will not pick up bobbin, and is definately hitting something by the bobbin, will not sew
My Singer Athena 09 drops the needle when ever the
it sounds like the needle clamp screw is not tight enough or is stripped out
some needle clamp screws have a **** where you can put a flat screw driver in to tighten & if that doesn't work then you need to check on getting a new needle clamp screw
Not finding what you are looking for?