20 Most Recent
Canon PIXMA MX850 Multifunction Printer - Page 5 Questions & Answers
How do i fine the
Here is a link with complete details on how to change ink cartridges:http://tinyurl.com/3o7fpx3
I'm getting an error code
Pls do the following
1. power OFF the printer
2. Unplug the printer's power cord from the electrical source.
3. Wait AT LEAST 1 minute - no less than 1 minute.
4. After 1 minute, plug-in the printer to the electrical source. Turn
on the printer - wait for it to warm up as usual and it should be ok...........
Thank u..............
PIXMA 850 is dead. Won't
Usually the problem with most printers are usually the power supply cable having some discrepancies in them. Check the power supply cable if it is intact first or you can get a different cable to test the unit as usually printers seldom have such problems that makes them just dead. Although when printers encounter problems that make them go just dead i advice not to try fixing them if the unit warranty has expired as the cost of fixing is usually about half the cost of replacing the unit. Check the power cable as that is the only part which you can fix yourself.
Hope this solution has been helpful?
Attach a Canon MX850 printer to my new
Hello.
Your computer can only add printers it sees, whether connected or networked.
You didn't indicate if other computers can print to that printer. If your new computer is the only one, I'd suggest to reinstall your WiFi printer and try to add the printer again.
Hope this helps.
Canon MX-850 is not outputting
When printers wont be in use for a while it is usually best to remove the cartridges which are located in the unit initially before being packed up. this is because the cartridge usually has an expiration date and could cause untold damage to the print head. Even when the cartridge does not get expired if not used it could get dry and also affect the print head.
First try to replace the cartridges with fresh ink cartridges incase the old ones are bad, but before you put the new ones make sure the printhead face where the cartridges make contact with are cleaned with cotton wool and light spirit to clear up any blockages on the surface. Then you can put in your new cartridges and run the test again.
Hope this solution has been helpful?
Canon MPX850 has a line
This can be caused by dirt on the glass, as well as other things. Also, The fault can be with the scanner's imager strip, or the ribbon cable or
sockets from the imager to the circuit board may have a problem, or some
component(s) in the scanner circuits may have failed.
If the scanner is out of warrenty, and if it is not a very expensive
scanner, it may not be feasible to service.
I have a Canon MX850
To reset the waste ink tank counter :
1: Power off printer
2: Hold Resume button then press and hold POWER, the beeper will sound once.
3: Hold POWER and release RESUME
4: Press RESUME twice, then release all buttons
5: When the indicator lights steady, press RESUME three or four times. The indicator should be orange.
6: Press Power to set data
Not finding what you are looking for?