Ariston Technologies Ariston AWD12 Front Load Washer/Dryer - Answered Questions & Fixed issues
Errore f6 lavatrice ariston wmg 923
F06: Selector Error
Overhaul CND (selector connector)
Overhaul Selector Connector
Control Selector/CND Continuity
Control Selector Motor
Replace Selector
Replace Card
Dado
1/6/2019 5:49:34 PM •
Ariston...
•
Answered
on Jan 06, 2019
•
1,114 views
How to unlock the door
Lamp
M flashes slowly when the appliance is switched on and
a waiting instructions and at the end of a cycle, indicating that the door can be opened. It flashes quickly when the door should not be opened. A steady light means the appliance has accepted the selected programme.
If you correctly use the appliance then defective can be interlock, wiring or board.
If the door is constantly locked then you can access to interlock by removing the top cover of washing machine.
Dado
10/28/2015 8:29:36 PM •
Ariston...
•
Answered
on Oct 28, 2015
•
449 views
HOW TO FIX O9 ERROR CODE?
F09: Machine Setup Error Found (AWD12)
Setup error or incompatible EEPROM
Control Microprocessor Version
Ask for EEPROM Spare Part indicating Microprocessor version
Reflash EEPROM
Check electronic controller
Dado
10/11/2015 6:49:02 PM •
Ariston...
•
Answered
on Oct 11, 2015
•
233 views
Ariston dishwasher lkf 720 has a problem on/off, washing and end indicator lights are flashing
Reading the error code
The fault on the appliance is signalled via:
1. the continuous rotation of the selector knob
2. the action, for the first 4', of the electrovalve and the drain pump
3. the door becomes unlocked
4. the led flashes: the number of flashes indicates the fault code; the code should be read as follows:
· each fast flash (2/3 flashes of the led very close together) represents one code value
· the fault code is evaluated by counting the number of flashes occurring at 3/4" intervals from one another
· stop counting when the washing machine waits the equivalent of approximately 8/9" between flashes
· the procedure is repeated by the appliance cyclically
After you determine which the alarm code appeared we will able specifically to help you.
Dado
3/1/2018 6:53:14 AM •
Ariston...
•
Answered
on Mar 01, 2018
•
1,988 views
Why does my machine fill up with water when it's not switched on?
Sounds like a faulty solenoid valve. Does the water over flow the door and run out onto the floor? The other possibility is that the electronics could be faulty energizing the coil when the machine is off but this is not likely. Do you turn the valves off at the source when you are not using the machine? This would be a simple fix versus going into the machine to find out if the coil is energized or to replace the solenoid valve.
12/4/2014 11:59:40 AM •
Ariston...
•
Answered
on Dec 04, 2014
•
58 views
Door Stuck after wash completed
You will have remove top cover, and release door latch from inside the front, with a screw driver pushing against the latch to open door.
It does mean that you probably have a faulty door lock, or broken door handle.
Please rate my fixya solution.
Thanks
8/30/2014 10:01:30 AM •
Ariston...
•
Answered
on Aug 30, 2014
•
2,574 views
Why my washing machine unable to switch on?
If there are no lights, check the fuse in the plug.
If the machine comes on but the drum does not move, the motor control circuit board probably has a burnt connection or bad joint. This may also be the cause of the fuse blowing.
6/6/2014 8:28:46 AM •
Ariston...
•
Answered
on Jun 06, 2014
•
140 views
Program knob
There is one for sale on eBay:
3/20/2014 8:49:55 AM •
Ariston...
•
Answered
on Mar 20, 2014
•
64 views
Would not power up
look for a reset button but I have a feeling its inside the machine. They want you to call service. I would call their help line on that one if its free or go to where you bought it and see what they say. If all else fails, try youtube, sorry. I have an LG and there is no common stuff with anything these days
2/20/2014 2:03:24 AM •
Ariston...
•
Answered
on Feb 20, 2014
•
245 views
Door locked,cant open
just get an old door from any ariston..hotpoint or indersit machine make sure it is the same size
1/12/2014 9:55:09 AM •
Ariston...
•
Answered
on Jan 12, 2014
•
567 views
Constant clicking of door lock
Suggestion: Try a little WD40 spray on the door, not on the machine. Close and open 2 or 3 times while plug is off the wall mains.Click if helped.
4/21/2013 10:28:09 AM •
Ariston...
•
Answered
on Apr 21, 2013
•
367 views
Washing machine overfilling with water.
Possible that the inlet valve is not controlled or faulty . check the voltage and see if the voltage is cut after the level is achieved. If not the water level sensor is defective.If the inlet is not controlled then the program controller is a suspect.
6/29/2012 11:07:15 AM •
Ariston...
•
Answered
on Jun 29, 2012
•
108 views
Not finding what you are looking for?