20 Most Recent Whirlpool Accubake RF362LXTT Electric Kitchen Range - Page 7 Questions & Answers

Wall Ovens , Whirlpool , Appliances. The error code F3 E2 is telling you the electronic control on the range detected a high temperature in the oven. This can be caused by a defective oven temperature sensor or the electronic range control (ERC) good luck https://www.6ya.com/mrmmike

I believe you need to replace the direct spark ignition module, but refer to the note below. Direct spark ignition module. NOTE: This part is often misdiagnosed. Use the wiring diagram and check for an open circuit through the gas valve. Also inspect the igniter and burner tube.

This is supposed to happen automatically. You might try removing power to the unit for 5 minutes and see if that fixes it. If that does nothing it will probably need a main control board, but should be tested as there are other possibilities.

The F1E1 error on Whirlpool ranges indicates a problem with the control board or the wiring to the electronic oven control board. You need to replace the control board. See part 15 of the cooktop diagram here: https://www.searspartsdirect.com/model-number/weg745h0fh0/1198/0124250.html . I hope this helps. Cindy Wells

Possibly oven sensor is bad. Most test at around 1080 ohms at room temperature with a multi meter set to ohms setting

Replace infinite switch for that burner

May be on Celsius instead of Fahrenheit. Check your user manual to change it.

Door switch may be defective

Control board issue most likely. Get a qualified service technician

F9 or F9 E0
The electrical outlet in the home or the electrical connection to the appliance may be miswired.
If your appliance was installed recently (within approximately 3 months), contact a qualified electrician to verify the electrical supply.
Unexpected power supply line "noise" during a power outage that the control detected as incorrect voltage may cause the code to display.
If any keys were pressed before a 10 second delay during power up could cause the code to display.
Resolution: Reset Power

F9 or F9 E0
The electrical outlet in the home or the electrical connection to the appliance may be miswired.
If your appliance was installed recently (within approximately 3 months), contact a qualified electrician to verify the electrical supply.
Unexpected power supply line "noise" during a power outage that the control detected as incorrect voltage may cause the code to display.
If any keys were pressed before a 10 second delay during power up could cause the code to display.
Resolution: Reset Power.

Turn power off at breaker for 30 sec turn back on then go to stove wait 1 min if code dosent come back then try using stove f9 is a power issue

Knobs are cheap if that’s all it is. What is model #?

Just tried to look your model up at searspartsdirect.com. Your model # as you furnished is not valid or incomplete

Power failure.

Are the surface burners getting hot in normal time?

Replace switch for that burner

Replace switch controlling that burner.

Most likely a power supply problem. Sounds like you are only getting 120 volts to unit instead of 240.

Sorry there is no adjustment for that.