20 Most Recent
Earthquake Sound PH-D2 Car Audio Amplifier - Page 2 Questions & Answers
Red light is on when i connect input cable earthquake 1000w amp
Cables are either shorted, or deck is putting out too much power for input on amp... many new head-units will put out up to 7v on the output jacks (RCA) the amp may only want to see up to 1v will need to consult head-unit manual for adjustment of outputs.
Orion 2100 hcca
That AMP is a power pig you need some yellow caps and an MBR 70
Whats wrong
If the outputs were blown, the 20 pin HIP4080 probably needs to be replaced.
Protection
Check speaker load. You might try starting with a 4ohm load per channel. Only one speaker per channel and DON'T bridge. If it now works OK then you are on the trail of the right answer. Good luck. If it is a speaker load problem, then you need to correct this at once before you fry your amp. Good luck.
How do you wire 2
What are you wiring too? What kind of amplifier?
What impedance are the voice coils on each speaker?
If you send me the above info I can better assist you with this dilema.
Help with code radio for my nissan pp2787h
The radio code is a security feature that's meant to deter theft, and it's unique to each vehicle. If you've lost your code, you'll need to contact a Nissan dealership or service center and provide proof of ownership. They should be able to help you retrieve the code. Please do not attempt to use codes from the internet as incorrect attempts may lock your radio.
Is there bluetooth on nsdn-w59
I have the same radio now with no Bluetooth am trying to get Bluetooth on it too without having to buy another radio. Please help.
No sound from wireless headphones in a toyota sienna
First thing to do is check to make sure that the batteries are properly charged.
Second, make sure that you have a clear line-of-site to the IR transmitter. Infrared (IR) works the same way that your TVs remote control works - if the signal is blocked, then you will not hear any sound.
Third, make sure that you are in the rear seat of the vehicle when listening to the sound. The IR transmitter only transmits to the rear seat, so you will not hear any sound if you are sitting in the front seats. This is a common problem that i see.
Lastly, make sure that the heapdhones you purchased are compatible with your 2006 2007 2008 2009 or 2010 Toyota Sienna. Remember that some older models require RF headphones, not IR headphones. I checked http://www.audiovideo2go.com for compatibility before I purchased my headphones. They have a useful listing of all the headphones and models of vehicles they are compatible with.
Not finding what you are looking for?