20 Most Recent
FoodSaver Smart Seal Vacuum Sealer V3825 - Page 2 Questions & Answers
Kenmore Beltless Vacuum brush will not spin.
there is a reset button on the side of the lower base of the machine, plug in the unit turn on the switch to the brush and vacuum are both engaged hit the reset button, remember the roller will not engage when the handle is in the upright position, release the handle and your ready to go.let me know if that helped you . thanks renevacdoc
2/3/2024 5:49:33 PM •
Vacuums
•
Answered
on Feb 03, 2024
Red light comes on after charging my ergorapido
I had the same problem. Red light would come on after charging was complete. On investigation I found that there is a small gray wire that runs from the rear batteries to a large solder spot on the control board. Upon re-soldering this wire I got an additional 3 V of power and the red light does not come on anymore after it is charged. I can vacuum the whole house and then some and still not run the batteries down.
2/3/2024 6:53:13 AM •
Vacuums
•
Answered
on Feb 03, 2024
I have a HeatStream Alert
Hello, I have one that I am selling. Let me know if you are interested. Great condition.
1/22/2024 9:43:33 PM •
Vacuums
•
Answered
on Jan 22, 2024
How to take off the handle once it is clicked in
I would check the user manual. That said, the following may or may not fit your model: Ensure that the hard floor cleaner is powered off and unplugged to avoid any accidents.
Push a flathead screwdriver into the hole guidance, located at the back towards the bottom of the handle.
The handle can then be released by pulling upwards.
If this does not work, you may need to contact the manufacturer's customer service. Don't be embarrassed about that. Devices are often tricky about assembly and disassembly and offer one very elusive way to come apart or require special tools.
1/11/2024 7:41:38 AM •
Vacuums
•
Answered
on Jan 11, 2024
This is the first time
yes you should get some kind of power indicated that power is on the machine i would first check the circuit breaker and then assure that you have power coming out of the outlet after which you could then use a multimeter to folow where you do have power going to sometimes it could also be a bad switch on the unit itself but first assure where you do have power going to and any further questions message me back Thanks Rick
1/4/2024 9:19:08 AM •
Vacuums
•
Answered
on Jan 04, 2024
The steamer is on, but does not produce any steam?
The most likely reasons are
the heating element has failed
or it is blocked with limescale
All question need full 'make model (what is is)' please. Very often specific models have 'history'.
Google
make model no steam
..
12/25/2023 11:35:49 PM •
Vacuums
•
Answered
on Dec 25, 2023
Can I use dovate ointment for piles?
NO! it is a topical steroid used for treatment of ezcema and
psoriasis........it makes the skin thinner and slows down
skin regeneration..would make the healing of piles slower
and more difficult. visit your doctor...in thr meantime
"Germoline" is pretty good
12/19/2023 2:47:53 PM •
Vacuums
•
Answered
on Dec 19, 2023
I need the ice pusher
I had a similar problem and fixed it myself. I can show u what I did if its the same problem.
12/8/2023 8:22:49 PM •
Vacuums
•
Answered
on Dec 08, 2023
Not finding what you are looking for?